User manual CANDY CDF718T

[. . . ] Gornja koara (slika 1) A = duboki tanjuri B = plitki tanjuri C = tanjuri za desert D = tanjuriçi od alica za kavu E = alice za kavu F = ãae Gornja koara (slika 2) A = duboki tanjuri B = plitki tanjuri C = tanjuri za desert D = tanjuriçi od alica za kavu E = alice za kavu F = vrãevi, krigle G = ãae H = koarica za jedaçi pribor Gornja koara (slika 5) A = 5 + 5 + 5 ãae B = 12+3 tanjuriça od alica za kavu C = 5 + 5 + 5 alica D = mala zdjelica E = srednje velika zdjela F = velika zdjela G = tanjuri za desert H = 1 + 1 Ïlice za posluÏivanje I = kutlaãa L = pribor za jelo 1 = 15 Ïlica za desert 2 = 15 vilica 3 = 12 Ïlica za ãaj Safety advice Setting up, installation Water softener unit Adjusting the upper basket Loading the dishes Information for test laboratories Half load washing Loading the detergent and rinse aid Cleaning the filters Some practical hints Routine cleaning and maintenance Identifying minor faults pag. There are certain basic safety rules which are valid for any domestic appliance. Knives and other utensils with sharp points must be loaded in the basket with their points down or placed in a horizontal position. I Make sure that the plug fitted to the machine is compatible with the power supply socket. [. . . ] I To add salt, unscrew the cap of the container on the bottom and then refill the container. I During this operation a little water will overflow; but keep adding salt until the container is full. When the container is full, clean the thread of salt residue and retighten the tap. I After loading the salt, it is recommended running a complete washing cycle, or COLD RINSE programme. 8 kg and, for efficient use of the appliance, it should be refilled from time to time according to the regulation of the water softener unit. IMPORTANT (Only for first start up) When the appliance is used for the first time, after completely filling the salt container, it is necessary to add water until the container overflows. Some models are provided with an indicator light which signals salt consumption. The signal will appear according to one of two systems: I an indicator light on the control panel which will light up when it is necessary to reload the salt container; I the salt container cap with a green mobile light (fig. 1a) which remains visible as long as there is enough salt for regeneration purposes. When the green surface is depressed inside the cap, more salt must be loaded. Other models are provided with a blind cap (fig. In this case, the salt level must be checked periodically, according to the regulation of the water softener unit. (some models only) If 27 cm to 31 cm plates are normally used, load them onto the lower basket after the upper basket has been placed in its upper position and proceed as detailed below (According to the models): Type "A": 1. Turn the front stops "A" outwards; 2. Dishes that are bigger than 20 cm in diameter can no longer be loaded onto the upper basket and the mobile supports cannot be used when the basket is in the upper position. IMPORTANT The appearance of white stains on dishes is generally an important sign that the salt container needs filling. Then grasp the basket from both sides and lift it upwards (fig. Dishes that are bigger than 20 cm in diameter can no longer be loaded onto the upper basket and the mobile supports cannot be used when the basket is in the upper position. Then slowly release into the correct position (fig. 3) A = medium-sized saucepan B = large saucepan C = frying pan D = tureens, serving dishes E = cutlery F = oven dishes G = medium bowl H = small bowl Please load the dishwasher sensibly to ensure the best wash results. IMPORTANT It is essential to use a detergent that is specifically designed for dishwashers either in powder, liquid or tablet form. "FINISH" gives very good results and can be easily obtained. [. . . ] When you have finished, refit the rotor arms in the same position, remembering to re-align the arrow and screw into position. I Both the door lining and the tank lining are in stainless steel; however, should spots caused by oxidation occur, this is probably due to a high level of iron salts presents in the water. I The spots can be removed with a mild abrasive agent; never use chlorine based materials, steel wool, etc. Should the dishwasher fail to operate, before contacting the Service Centre, make the following checks: CAUSE Plug is not connected to wall socket REMEDY Connect electric plug Press button Close door Check the fuse in the plug and the electricity supply Check Turn water tap on Turn programme selector to correct position Eliminate the bends in the hose Clean the filter at the end of the hose Clean filter Straighten outlet hose Follow the instructions for connecting the outlet hose carefully Call a qualified technician Programme selector is not at correct position The inlet hose is bent The inlet hose filter is not correctly connected Filter is dirty Outlet hose is kinked After every wash it is essential to turn off water supply and to switch off the machine by pressing the On/Off button to the off position. [. . . ]