User manual CANDY CDH 32/1 C

[. . . ] Adjusting power and the timer by means of the “+” and “-” keys Use the “+” and “-” keys (4) to adjust the setting of the plates and the required time on timer/minute counter (7). The “+” and “” controls (4) are common to both functions. Accordingly, to regulate the power of the hob, first select the zone with key (2), then adjust the relative power level using the “+” and “-” keys (4); this done, select the timer function with key (6) and proceed to set the duration, likewise using the “+” or “-” key (4). GB Press and hold down these keys to increase or decrease the setting. [. . . ] The letter “A” will be shown on the relative display. GB To preheat the unit with spontaneous movement towards the required power level (e. €6”), set the power to 6 by means of the “-” key (4). After the system has set to automatic preheating mode, the display panel will alternate the set power level (“6”) and the automatic preheating function (indicated by the letter “A”). Switching off the automatic preheating function To deactivate the preheating function (indicated by the letter “A” on the display), press the “-” key (4) at least 10 seconds since the function has been activated. Timer function This function too simplifies operation by not requiring human supervision during the cooking cycle. Once the set time on the timer has elapsed, the cooking area is automatically switched off. If no zone has been programmed, the timer simply operates as a minute counter (see the section “Using the timer as a minute counter”). The cooking area must already be activated with relative decimal point (12) illuminated. Press the timer key (6); the timer display shows “00” and the indicator (10) relative to the zone being programmed lights up. Select the cooking time (between 0 to 99 minutes) by means of the “+” and “-” keys (4). The timer will start up automatically in a few seconds. Press and hold down the “+” or “-” key (4) to scroll the time setting. Note that the timer function applies to the selected cooking area only. Using the timer as a minute counter When the timer function is not programmed, the timer display can be used simply to count down minutes (i. When the displayed time elapses, the cooking area is not deactivated). GB Setting the minute counter When the unit is off: FR Configuration du compte-minutes : Si le dispositif est éteint : 1. Press the ON key 1 – Toucher la touche (1). When the unit is on and a cooking area is activated: Si le dispositif est allumé et une zone de cuisson est active : 1. Set the time required by 2 – Toucher la touche du means of the “+” and “-” minuteur (6). Deactivating the minute counter function When the set time has elapsed, an acoustic signal is emitted for two minutes. to interrupt the timer , proceed as follows: 1. [. . . ] Apply the seal supplied over the whole perimeter of the working area. 6) Prior to carrying out the electrical connection, please ensure that: - the plant characteristics are such as to follow what is indicated on the matrix plate placed at the bottom of the working area; - that the plant is fitted with an efficient earth connection, following the standards and law provisions in force. The earth connection is compulsory in terms of the law. Should there be no cable and/or plug on the equipment, use suitable absorption material for the working temperature as well, as indicated on the matrix plate. [. . . ]