User manual CANDY CDI 2D36

[. . . ] Any faults arising from operation at incorrect voltage. Any faults arising from incorrect operation of the machine. The guarantee applies to Gt Britain and Northern Ireland only, and is an addition to your statutory rights. For service and repairs call your local engineer on our national telephone number: EN 50242 place load Capacity with pans and dishes Water supply pressure (MPa) Fuse / Power input / Supply voltage Power consumption of the off-mode and of the left-on mode: 0, 45 W / 0, 45 W *Values are measured in a laboratory according to European Standard EN 50242 (consumption may vary according to conditions of usage). [. . . ] To start the countdown, press the "START" button. At the end of the countdown, the programme will automatically start. If you wish to see which programme has been selected, press the "PROGRAMME SELECTION" button. Hold the "RESET" button down for at least 3 seconds. "00" will appear on the display and some audible signals will sound. The delayed start and the selected programme will be cancelled. Press the same button again ("b0" will appear on the display to indicate that the alarm is off). Turn off the dishwasher by pressing the "ON/OFF" button to confirm the new setting. To turn the alarm on again, follow the same procedure. At this point, a new programme and option buttons must be set to start a new programme as indicated in the "PROGRAMME SETTINGS" section. Memorization of the last programme used The last programme used can be memorized by following the below: The alarm for the programme end may be muted as follows: IMPORTANT The dishwasher must ALWAYS be off before start of this procedure. IMPORTANT The dishwasher must ALWAYS be off before start of this procedure. Hold down the "PROGRAMME SELECTION" button and at the same time switch on the dishwasher by pressing the "ON/OFF" button (a brief audible signal will sound). Keep the "PROGRAMME SELECTION" button pressed for at least 15 seconds (during this time 2 audible signals will sound). Release the button when the second audible signal sounds ("b1" will appear on the display to indicate that the alarm is on). Hold down the "PROGRAMME SELECTION" button and at the same time switch on the dishwasher by pressing the "ON/OFF" button (a brief audible signal will sound). Keep the "PROGRAMME SELECTION" button pressed for at least 30 seconds (during this time, 3 audible signals will sound). Release the button when the THIRD audible signal sounds ("A0 " will appear on the display to indicate that the memorization is off). Press the same button again ("A1" will appear on the display to indicate that the memorization is on). Turn off the dishwasher by pressing the "ON/OFF" button to confirm the new setting. To disable the memorization, follow the same procedure. IMPORTANT This dishwasher is equipped with an anti-overflow safety device which will automatically discharge any excess water should a problem occur. [. . . ] The current water softener setting level will be shown on the display. Press the same button again to select the required water softener level: each time the button is pressed, the setting will increase by one level. When you have reached "d7", the display will go back to "d0". Turn off the dishwasher by pressing the "ON/OFF" button to confirm the new setting. [. . . ]