User manual CANDY CDI2D36

[. . . ] Any faults arising from operation at incorrect voltage. Any faults arising from incorrect operation of the machine. The guarantee applies to Gt Britain and Northern Ireland only, and is an addition to your statutory rights. AFTER SALES SERVICE For service and repairs call your local engineer on our national telephone number: GIAS Service Support Service Tel: 08444 995599 (Eire 0818 200021) 12 DESCRIPTION OF THE CONTROL PANEL A B C D E "ON/OFF" button "PROGRAMME SELECTION" button "DELAY START" button "EXPRESS" option button "ALL IN 1" option button F G H I DIMENSIONS "START"/"RESET" button (start/cancelling programme) "OPTION SELECTION" lights DIGITAL DISPLAY Programme guide Width x Height x Depth (cm) Depth with door open (cm) 59, 8 x 81, 8 ÷ 89, 8 x 55 117 TECHNICAL DATA EN 50242 place load Capacity with pans and dishes Water supply pressure (MPa) Fuse / Power input / Supply voltage 13 8 persons Min. [. . . ] By pressing this button, the selected washing programme is modified to get best performance from combined detergents (furthermore, the salt empty alert will be de-activated). – Press the button again to increase the delay in hours (each time the button is pressed the delay is increased by 1 hour to a maximum of 23). Once selected, this option keeps being on (light on) also for next washing cycles and it can be de-activate (light off) only by pressing the button once again. 15 ■ To start the countdown, press the "START" button. At the end of the countdown, the programme will automatically start. If you wish to see which programme has been selected, press the "PROGRAMME SELECTION" button. proceed as follows to cancel a delayed start: 4. Press the same button again ("b0" will appear on the display to indicate that the alarm is off). – Hold the "RESET" button down for at least 3 seconds. "00" will appear on the display and some audible signals will sound. Turn off the dishwasher by pressing the "ON/OFF" button to confirm the new setting. To turn the alarm on again, follow the same procedure. ■ The delayed start and the selected programme will be cancelled. IMPORTANT The dishwasher must ALWAYS be off before start of this procedure. Hold down the "PROGRAMME SELECTION" button and at the same time switch on the dishwasher by pressing the "ON/OFF" button (a brief audible signal will sound). Hold down the "PROGRAMME SELECTION" button and at the same time switch on the dishwasher by pressing the "ON/OFF" button (a brief audible signal will sound). Keep the "PROGRAMME SELECTION" button pressed for at least 30 seconds (during this time, 3 audible signals will sound). Release the button when the THIRD audible signal sounds ("A0 " will appear on the display to indicate that the memorization is off). Press the same button again ("A1" will appear on the display to indicate that the memorization is on). Keep the "PROGRAMME SELECTION" button pressed for at least 15 seconds (during this time 2 audible signals will sound). Release the button when the second audible signal sounds ("b1" will appear on the display to indicate that the alarm is on). Turn off the dishwasher by pressing the "ON/OFF" button to confirm the new setting. [. . . ] If water has leaked from the main inlet pipe there will be a visible sign within the transparent hose. You may continue to complete the programme cycle but for safety we recommend the immediate replacement of the complete hose assembly. If the hose is not long enough for correct connection, it must be replaced with a longer one. The hose can be obtained from a Service Centre. [. . . ]