User manual CANDY CDIN 4D340PB

[. . . ] We are confident it will assist you loyally in washing your daily dishes in full safety. Carefully read this manual for correct and safe appliance use and for helpful tips on efficient maintenance. Only use the dish washer after carefully reading these instructions. We recommend you always keep this manual to hand and in good condition for any future owner. [. . . ] If the machine is left in places where the temperature is below 0°C any water left inside the pipes may freeze. Wait until the temperature rises above zero and then wait for about 24 hours before. G "Start/Reset" button (start/cancel programme) H "Addish" light I "SMART DOOR" light L "TABS" light M "Wi-Fi" light Place settings (EN 50242) Capacity with pans and dishes Water supply pressure (MPa) L Close the door (after an audible signal has sounded, the programme will start automatically). L To turn the appliance on and off, press the ON/OFF button (for at least 3 seconds). At the end of the cycle, remember to switch off the appliance using the ON/OFF button, then remove the plug and close the water supply. In the event that the machine remains switched on without selecting or starting any program, after 5 mins. The dishwasher will switch off automatically. Next time you switch on the appliance First time you switch on the appliance L Connect the machine to the power supply. L Open the door, put the dishes to be washed inside, and close the door again. L Press the "ON/OFF" button and hold for about 3 seconds. L In this phase only the "SMART DOOR/ EXPRESS" "TABS" and "Start/ Reset" buttons will remain active. The message "BRAVA" will appear on the display and all the indicator lights will turn on for 3 secs. l The message "ENGLISH" will appear on the display. L Pressing the "SMART DOOR/EXPRESS" and "TABS" buttons you can select the preferred language. L To accept the language selection press the "Start/Reset" button Immediately afterwards the "WELCOME" message will scroll on the display once and the indicator lights will all be off. l The message of the "ECO 2:50" or "ECO 3:25" programme (with SMART DOOR option activated). L Press "Start/Reset" and a signal will sound, the indicator light corresponding to the selected programme will stay on and the wash indicator light will come on. L Hold down the ON/OFF button for about 3 Secs to turn the machine on and the "ECO 2:50" programme or the programme you have decided to use will appear on the display, saving it when the dishwasher is switched on. (To save the programme, see the specific paragraph "Memorising the last programme used"). settings Menu The dishwasher is regulated with certain factory settings. Nevertheless, from the Settings menu, you can adjust various parameters to suit your washing requirements. entering the Settings menu The dishwasher must ALWAYS be off before you start this procedure. [. . . ] If the fault persists, contact the Technical Assistance Centre. This dishwasher is equipped with an overflow safety device that, in the event of a problem, automatically discharges any excess water. To ensure the correct operation of the overflow safety device, we recommend not moving or tilting the dishwasher during operation. Should it be necessary to tilt or move the dishwasher, please ensure that the washing cycle is complete and that no water remains inside the appliance. [. . . ]