User manual CANDY CDPM 95390XF

[. . . ] Transmission rate (over the air) Receive sensitivity 1-11 Mbps for 802. Thank you for choosing a Candy appliance; quality dishwashers which guarantee high performance and reliability. candy manufacture a vast range of domestic appliances: washing machines , washer/dryers , cookers , microwave ovens , ovens and hobs , refrigerators and freezers. Ask your dealer for the catalogue with the complete range of Candy products. [. . . ] ■ The delayed start and the selected programme will be cancelled. Press the same button again ("A1" will appear on the display to indicate that the memorization is on). Turn off the dishwasher by pressing the "ON/OFF" button to confirm the new setting. To disable the memorization, follow the same procedure. IMPORTANT This dishwasher is equipped with an anti-overflow safety device which will automatically discharge any excess water should a problem occur. To ensure the correct operation of the anti-overflow safety device, we recommend that the dishwasher is not moved or tilted during operation. If however it is necessary to tilt or move the dishwasher, please ensure that the washing cycle is complete and that there is no remaining water inside the dishwasher. IMPORTANT The dishwasher must ALWAYS be off before start of this procedure. Hold down the "PROGRAMME SELECTION" button and at the same time switch on the dishwasher by pressing the "ON/OFF" button (a brief audible signal will sound). Keep the "PROGRAMME SELECTION" button pressed for at least 30 seconds (during this time, 3 audible signals will sound). Release the button when the THIRD audible signal sounds ("A0 " will appear on the display to indicate that the memorization is off). The dishwasher is able to signal a series of faults in the display. aUTOMATIC FAULT SIGNALS FAULTS CAUSE No water (inlet hose closed). SOLUTION Turn off the dishwasher, open the inlet hose and reset the cycle. E2 appears on the display and the alarm sounds. E3 appears on the display and the alarm sounds. Check if the drain tube is bent or if the siphon or filters are clogged. if the problem persists , contact Customer Service. E4 appears on the display and the alarm sounds. Water leak Check if the drain tube is bent or if the siphon or filters are clogged. E5, E6, E7, Ef or EL appears on the display and the alarm sounds. E8 or Ei appear on the display and the alarm sounds. [. . . ] If the door is not closed, then it will not be possible to start a wash cycle, but it is possible to use the Simply-Fi app. - POWER CONTROL: The app is able to show the levels of energy consumption at various stages of the wash cycle, as well as providing daily and weekly energy reports. Furthermore, once the cost of the household electricity supply is determined, the app will suggest the best time to use the dishwasher. - DIAGNOSTICS: The app informs the user about any errors or problems that may occur during the wash cycle (e. [. . . ]