User manual CANDY CDPN 1L390PX

[. . . ] We are confident it will assist you loyally in washing your daily dishes in full safety. Carefully read this manual for correct and safe appliance use and for helpful tips on efficient maintenance. Only use the dish washer after carefully reading these instructions. We recommend you always keep this manual to hand and in good condition for any future owner. [. . . ] L The spots can be removed with a mild abrasive agent; never use chlorine based materials, steel wool, etc. L If, in spite of the routine cleaning of the filters, you notice that the dishes or pans are not properly washed or rinsed, check that all the spray heads on the rotor arms (fig. If they are blocked, clean them in the 1) to remove the upper rotor arm, turn it until it lines up with the stop marked by the arrow (fig. 1) and, keeping it pushed in, unscrew it in a clockwise direction (to reassemble it repeat the same operation, but turn it anticlockwise). The lower rotor arm can be removed simply by pulling it upwards (fig. 2); 2) wash the rotor arms under a jet of water to clear any blockage in the spray heads. After every wash it is essential to turn off water supply and to switch off the machine by pressing the On/Off button to the off position. If the machine is not going to be used for some time, it is advisable to follow these rules: 1. Do an empty wash with detergent in order to clean the machine of any deposits; 2. Turn off the water tap; Keep the inside of the machine clean; 7. If the machine is left in places where the temperature is below 0°C any water left inside the pipes may freeze. Wait until the temperature rises above zero and then wait for about 24 hours before. A ON/OFF Button B "PROGRAMME SELECTION" button/ENROLMENT Wi-Fi C "Express" option button D C+E CHILD LOCK E "START DELAY" button F Reset" button for "SALT EMPTY" light G "Start/Reset" button (start/cancel programme) H "RINSE AID EMPTY" light I "PROGRAMME STATUS" lights/"DELAY START" time lights L "OPTION SELECTION" light M "PROGRAMME SELECTION" light N "Addish" light Place settings (EN 50242) Capacity with pans and dishes Water supply pressure (MPa) PROGRAMME SELECTION Next time you switch on the AND SPECIAL FEATURES appliance L To turn the appliance on and off, press the ON/OFF button (for at least 3 seconds). At the end of the cycle, remember to switch off the appliance using the ON/OFF button, then remove the plug and close the water supply. Hold down the ON/OFF button for about 3 sec. To turn the machine on, and the "P3"programme indicator light will come on. If you have turned on the programme memorisation function, the indicator light corresponding to the last programme completed will appear on the display. First time you switch on the appliance L Connect the machine to the power supply. L Open the door, put the dishes to be washed inside, and close the door again. L Press the "ON/OFF" button and hold for about 3 seconds. L At this time only the "ON/OFF" and "Progr. " buttons will be active, and all the programme indicator lights will come on for 3 sec. [. . . ] This dishwasher is equipped with an overflow safety device that, in the event of a problem, automatically discharges any excess water. To ensure the correct operation of the overflow safety device, we recommend not moving or tilting the dishwasher during operation. Should it be necessary to tilt or move the dishwasher, please ensure that the washing cycle is complete and that no water remains inside the appliance. Dishwasher does not fill with water Spray arms are not heard to rotate CAUSE Plug not connected to wall socket O/I button not pressed Door is open No electricity See point 1 The water tap is closed The water supply hose is bent The filter of the water supply hose is clogged Filter is dirty Drain pipe is bent The drain pipe extension is not correctly connected The outlet connection on the wall is pointing downwards not upwards Position of the drain pipe is too low excessive amount of detergent Item prevents arms from rotating Filtering plate and filter very dirty SOLUTION Connect electric plug Press button Close door Check Check Open the water tap Eliminate the bends in the hose Clean the filter at the end of the hose Clean filter Eliminate the bends in the pipe Follow the instructions for connecting the drain pipe carefully call a qualified technician Lift drain pipe to at least 40 cm above floor level Appliances without a display: one or more indicator lights flashing quickly The dishes are not completely dry Turn on the tap. [. . . ]