User manual CANDY CDPN 2D520PW/E

[. . . ] We are confident it will assist you loyally in washing your daily dishes in full safety. Carefully read this manual for correct and safe appliance use and for helpful tips on efficient maintenance. Only use the dish washer after carefully reading these instructions. We recommend you always keep this manual to hand and in good condition for any future owner. [. . . ] Wait until the temperature rises above zero and then wait for about 24 hours before. G "TABS" option button H "Start/Reset" button (start/cancel programme) I "ADDISH" light L "TABS" Light M "EXPRESS" Light N "Wi-Fi" light Place settings (EN 50242) Capacity with pans and dishes Water supply pressure (MPa) L To turn the appliance on and off, press the ON/OFF button (for at least 3 seconds). In the event that the machine remains switched on without selecting or starting any program, after 5 mins. The dishwasher will switch off automatically. At the end of the cycle, remember to switch off the appliance using the ON/OFF button, then remove the plug and close the water supply. First time you switch on the appliance L Connect the machine to the power supply. L Open the door, put the dishes to be washed inside, and close the door again. L Press the "ON/OFF" button and hold for about 3 seconds. Next time you switch on the appliance The dishwasher is regulated with certain factory settings. Nevertheless, from the Settings menu, you can adjust various parameters to suit your washing requirements. L In this phase only the "SMART DOOR/ EXPRESS" "TABS" and "Start/ Reset" buttons will remain active. The message "BRAVA" will appear on the display and all the indicator lights will turn on for 3 secs. l The message "ENGLISH" will appear on the display. L Pressing the "SMART DOOR/EXPRESS" and "TABS" buttons you can select the preferred language. L To accept the language selection press the "Start/Reset" button Immediately afterwards the "WELCOME" message will scroll on the display once and the indicator lights will all be off. The dishwasher must ALWAYS be off before you start this procedure. L Turn on the dishwasher by holding the "ON/OFF" button down for about 3 secs. L The message "SETTINGS" will appear on the display and the indicator lights of the "SMART DOOR/EXPRESS" and "TABS" buttons will be on. " button you can select the parameters to be adjusted in succession (SOFTENER BUZZER MEMO FUNCTION). l To adjust the SOFTENER see the specific Chapter of the manual. L To adjust the BUZZER see the specific paragraph. L To adjust the MEMO FUNCTION see the specific paragraph. [. . . ] If the fault persists, contact the Technical Assistance Centre. This dishwasher is equipped with an overflow safety device that, in the event of a problem, automatically discharges any excess water. To ensure the correct operation of the overflow safety device, we recommend not moving or tilting the dishwasher during operation. Should it be necessary to tilt or move the dishwasher, please ensure that the washing cycle is complete and that no water remains inside the appliance. [. . . ]