User manual CANDY CDS 450 X

[. . . ] Please read this booklet carefully as it provides important information regarding the safe installation, use, and maintenance of the machine, together with some useful advice on how to achieve the best results from your dishwasher. For future reference please keep this instruction booklet in a safe place. Your new appliance is fully guaranteed by the manufacturer for 12 months against electrical/mechanical breakdown excluding: A. [. . . ] If you wish to change or cancel the programme that is running, carry out the following: turn the programme selector to "RESET" position. The dishwasher will automatically empty the water and after a few seconds the indicator light "WASHING" will go off. Turn the programme selector to "RESET" position, wait until the indicator light "WASHING" goes off and press the "ON/OFF" button. IMPORTANT This dishwasher is equipped with an anti-overflow safety device which will automatically empty any excess water should a problem occur. Before to set any programme, the programme selector must be in the "RESET" position and the indicator light "WASHING" ( ) must be out. Whenever you want to set a new programme, you MUST turn the programme selector to "RESET" position and wait for the "WASHING" indicator light to go off. To ensure the correct operation of the anti-overflow safety device, it is recommended not to move or to tilt the dishwasher during operation. If it is necessary to move or to tilt the dishwasher, first make sure the washing cycle is finished and that no water is left in the tank. To set the programme, press the "ON/OFF" button: then turn the dial (in a clockwise or anti-clockwise direction) until the pointer is in line with the number of the required programme. After about 4 seconds, the indicator light "WASHING" will come on. While you are setting a programme, the indicator light "WASHING" will start flashing very quickly if the electronics detect some incorrect programming function. In this case, turn the programme selector to the "RESET" position and the indicator light "WASHING" will then go off. After this you should again set the required programme. IMPORTANT While a programme is running, the programme selector will remain in the selected position, and will NOT MOVE. Before starting a new programme, you should check that there is still detergent in the dispenser. If there is any break in the power supply while the dishwasher is operating, a special memory stores the selected programme and, when the power is restored, it continues where it left off. "HALF LOAD" button By using this option, it is possible to wash a smaller quantity of crockery: you should load only the upper basket for dishes and place cutlery in the tray in the bottom basket. This reduces water and energy consumption and requires a smaller quantity of detergent. [. . . ] Would this occur, please refer to your Service Agent. If the hose is not long enough for correct connection, it must be replaced with a longer one. The hose can be obtained from your Service Agent. [. . . ]