User manual CANDY CDW 252 ALTERNATIVE

[. . . ] the program end LED will light and the display will go blank. Dishes can now be removed and the dishwasher turned off by pressing the "ON/OFF" button or dishes can be loaded for a new cycle. Open the door and place dirty dishes inside the appliance. The dishwasher is equipped with a dirt sensor, able to analyse water murkiness during all "AUTOMATIC" program phases (see program list); thanks to this sensor the washing cycle parameters are automatically adapted to the real quantity of dirt on dishes. [. . . ] The cycle will start from where it left off (if it is necessary, the appliance will make a short thermal anti-shock programme before). IMPORTANT All options MUST be turned on or off, BEFORE starting the program. - the "Auto' Memory", function which saves a program used at least 3 times consecutively so that if you regularly use the same washing cycle each time you do not have to continually set the program thereby saving time and effort. to select an option , press the corresponding button (the LED will turn on). Option buttons must be pressed BEFORE starting the program for them to be accepted. The program starts automatically, the relevant LED will stop blinking and remain on and the cycle length will appear on the display. If the previously described operations were performed with the door open, the program will not start until the door is closed. Before starting a new programme, you should check that there is still detergent in the dispenser. If there is any break in the power supply while the dishwasher is operating, a special memory stores the selected programme and, when the power is restored, it continues where it left off (if it is necessary, the appliance will make a short thermal anti-shock programme before). "ECO" button The "ECO" button provides over 20% time and energy savings by reducing the final water heating and drying times during the last rinse cycle. This option is recommended for light soil washes, and for when the dishes are not required perfectly dry straight away. To ensure the correct operation of the anti-overflow safety device, it is recommended not to move or to tilt the dishwasher during operation. If it is necessary to move or to tilt the dishwasher, first make sure the washing cycle is finished and that no water is left in the tank. The waterblock system has been designed to improve the safety of your appliance, particularly when the machine is left unattended. The waterblock system actually prevents flooding which might be caused by a machine malfunction or as a result of a fracture on the pipes. How does waterblock work The sump located in the base of the appliance collects any possible water leakage and operates a sensor which subsequently activates a valve placed under the water tap and stops any water from the supply even with the tap fully opened. If the box containing the electrical parts is damaged, remove the plug from the socket immediately. To ensure perfect operation of the safety system, box "A" with the hose, should be connected to the tap as shown in figure "1". The inlet hose should not be cut, as it contains parts under load. If the hose is not long enough for correct connection, it must be replaced with a longer one. The hose can be obtained from your Service Agent. This dishwasher is also equipped with an anti-overflow safety device which, if water exceeds normal levels due to malfunctions, automatically blocks water flow and/or drains excess quantities. [. . . ] When you have reached "d7", the display will go back to "d1". When the required setting appears on the display, wait for an audible signal to confirm that the new setting has been stored in memory. The water softener can treat water with a hardness level of up to 90°fH (French grading) or 50°dH (German grading) through 8 settings. With cold water (15°C)** -Tolerance ± 10%Hot rinse with rinse aid Wash with prewash If setting the INTENSIVE wash programme, a second dose of about 20 g of detergent (1 table-spoon) must be added directly in the machine. [. . . ]