User manual CANDY CE 823 T

[. . . ] Ask your local retailer for the complete catalogue of Candy products. Please read this booklet carefully as it provides important guide lines for safe installation, use and maintenance and some useful advise for best results when using your washing machine. Keep this booklet in a safe place for further consultation. When contacting Candy or a Customer Services Centre always refer to the Model, No. [. . . ] When you have carried out the manoeuvre, close the door, press START button and the appliance will continue working where it left off. EN DOOR LOCKED INDICATOR The "Door Locked" indicator light is illuminated when the door is fully closed and the machine is ON. When START is pressed on the machine with the door closed the indicator will flash momentarily and then illuminate. if the door is not closed the indicator will continue to flash. A special safety device prevents the door from being opened immediately after the end of the cycle. Wait for 2 minutes after the wash cycle has finished and the Door Locked light has gone out before opening the door. EN "DIGITAL" DISPLAY The display's indicator system allows you to be constantly informed about the status of the machine: 1) WASH TEMPERATURE When a programme is selected the relevant indicator will light up to show the recommended wash temperature. The Temperature button can be used to decrease or increase the temperature of your chosen wash cycle. Each time the button is pressed, the new temperature level is shown on the Wash Temperature Indicator. 2) DOOR LIGHT Once the START/PAUSE button has been pressed the light first flashes then stops flashing and remains on until the end of the wash. 2 minutes after the end of the wash the light goes off to show that the door can now be opened. SPECIAL "RINSE" PROGRAMME This programme carries out three rinses with a intermediate spin (which can be reduced or excluded by using the correct button). It can be used for rinsing any type of fabric, eg. This program can be also used as cycle of Bleaching (see table of washing cycle programmes). SPECIAL "FAST SPIN" PROGRAMME Programme "FAST SPIN" carries out a maximum spin (which can be reduced by using the correct button). To be able to wash together different type of fabrics (e. To wash with a considerable energy saving. The "Mix & Wash" programme has a temperature of 40°C and alternate dynamic phases (the basket that turns) to static phases (fabrics in soak in phase of rest) with a duration programme that almost reaching the 2 hours. The energy consumption for the complete cycle is only 850 W/h. The first washing of new coloureds fabrics must be done separately; · In every case, never mix NON-FAST COLOUREDS fabrics. This programme is particularly suited to slightly dirty cottons and mixed fabrics. Using the Degree of soiling button on the Rapid cycle will enable you to select either a 14, 30 or 44 minute wash cycle. [. . . ] Turn off the water supply after every use. Min 1 Kg from 30' from 30' from 30' Min 1 Kg from 30' from 30' from 30' The appliance calculates the time to the end of the selected programme based upon a standard loading, during the cycle, the appliance corrects the time to that applicable to the size and composition of the load. Removals or long periods when the machine is left standing. Although not strictly necessary, it is advisable to clean the detergent, bleach and additives compartments occasionally. [. . . ]