User manual CANDY CGE650S 93786248 IT GB

[. . . ] Disposal must be carried out in accordance with local environmental regulations for waste disposal. For more detailed information about treatment, recovery and recycling of this product, please contact your local city office, your household waste disposal service or the shop where you purchased the product. Leave the power plug accessible even after the installation of the apparatus. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard. [. . . ] The rating plate is inside the appliance, in the bottom left-hand corner of the fridge compartment. The manufacturer may not be held liable for any damage caused by unearthed wiring systems. After you have installed the fridge, wait for at least two hours before turning it on. To ensure your appliance works as efficiently as possible, leave at least a 5 cm gap between the fridge and the wall and between the fridge and items behind or above it (1). If your fridge is equipped with 2 wall spacers, apply these to the condenser on the rear side of the fridge and in the direction of the arrows, as shown in figure (2). WALL SPACERS If your fridge is made of stainless steel or other special finishing, it may come with a peel-off film which is designed to protect its surface. In order to remove the said protection, it is not recommended to use sharp objects that might damage the stainless steel or any other finishing. NO Do not install the appliance outside. The appliance works properly at the following temperature ranges: Climatic class: SN +10 +32°C Climatic class: N +16 +32°C Climatic class: ST +16 +38°C Climatic class: T +16 +43°C (See appliance`s rating plate) RECOMMENDATIONS We recommend the following, for greater energy saving: - Do not put hot foods in the fridge. - Do not pack foods close together as this prevents air circulating. - Make sure foods do not touch the back of the fridge. - If the electricity goes off, do not open the fridge door. - Do not open or keep open the appliance doors for too long. compartments. Remove the light bulb and replace with the same type and same watt bulb. Trouble-shooting Please contact our service department if you have any difficulties. However you can often solve small or apparently alarming problems yourself. In fact problems may be caused by incorrect use or installation or by unsuitable ambient conditions and in these cases you will be charged. THE FRIDGE DOES NOT WORK - Make sure the plug is inserted properly in the socket. - Make sure the thermostat is not set to , , 0" or Stop. THE FRIDGE IS NOT COLD ENOUGH - Make sure the thermostat is set properly. - Make sure the fridge doors have not been left open for too long. - Make sure you haven`t stored too much food in the fridge. - Make sure you haven`t put hot foods in the fridge. THERE IS TOO MUCH FROST - Make sure the door has not been left open for too long. Unplug the fridge, defrost and then turn it back on. [. . . ] Unplug the fridge, defrost and then turn it back on. - Make sure the thermostat is not set at a temperature which is too cold (high settings). THERE IS TOO MUCH CONDENSATION - Make sure the door has not been left open for too long. - Make sure you haven`t stored too many fresh foods in the fridge. [. . . ]