User manual CANDY CHD90

[. . . ] Secure the metal bracket (B) to the wall using the screws and plugs (bracket, screws and plugs are all supplied with the unit). Use the 2 triangles cut into the bracket to position it precisely along the vertical axis of the hood. Adjust the horizontal position, shifting the hood to the right or left as needed lining it up with the wall units. [. . . ] Filtering hood: Secure the deflector to the upper flue using the 4 special screws (provided) ­ Fig. Take the 2 assembled extension flues and set them on the hood; extend the upper flue to the ceiling and secure with the 2 screws (G) - Fig. Extend the lower flue taping it in place and then connect the flexible pipe to the hood reduction. Extend the lower flue downward setting it against the hood. Install the charcoal filters by pressing the 2 tabs on the filter down into the special housing (Fig. Depending on the model, the unit is equipped with the following controls: Controls shown in Fig. Button B = turns the TIMER on/off: press once to turn the timer on, therefore, after 5 minutes, the motor cuts out (at the same time the selected speed blinks on the display); the timer remains on if the motor speed is changed. Indicates Timer On when the number blinks; - indicates Filter Alarm when the central segments is on or blinking. Button D= makes the motor work (at the last speed selected); pushing the button again, the speeds of the motor are sequentially selected from 1 to 4; keeping this button pressed for about 2 seconds shuts down the motor. When the central segment on the display goes on), the grease filters must be cleaned (30 hours of operation); when the central segment starts blinking, the grease filters must be cleaned and the charcoal filters replaced (120 hours of operation). Obviously, if the hood is not a filtering model and does not have a charcoal filter, clean the grease filters both when the central segment goes on and when it starts blinking. The filter alarm can be seen when the motor is off and for about 30 seconds. To reset the hour counter, keep the button pressed for 2 seconds while the alarm can be seen. 18/19: Switch A: LIGHT; position 0: light off; position 1: light on. [. . . ] Replacing the charcoal filters: If the unit is a filtering hood, the charcoal filters must be replaced: to remove them press inward on the clamp (Fig. 16) and rotate the filter downward until the 2 tabs can be removed from the housing. If the model purchased has the controls shown in Figure 17, the charcoal filters must be replaced whenever the central segment of the display starts blinking (i. [. . . ]