User manual CANDY CHSVN 174X

[. . . ] Before using your refrigerator, please carefully read this instruction manual in order to maximize its performance. Store all documentation for subsequent use or for other owners. This product is intendedsolely for household use or similarapplications suchas: 1. The kitchen area for personnel in shops, offices and For catering services andsimilarapplications not for retail sale. [. . . ] The symbol Kon the productor on its packaging indicates that this product may not be treated as household waste. Instead it should be taken to the appropriate collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. For more detailed information about recycling of this product, please contact your local council, your household waste disposal service or the shop where you purchased the product. Packaging materials The materials with the symbol are recyclable. This appliance is marked according to the European directive 2012/19/EU on Waste Electrical and Electronic Equipment (WEEE). WEEE contains both polluting substances (which can cause negative consequences for the environment) and basic components (which can be re-used). It is important to have WEEE subjected to specific treatments, in order to remove and dispose properly all pollutants, and recover and recycle all materials. Then remove another door as same process X Select a location with enough space for the refrigerator doors to open easily; X Select a location with level (or nearly level) flooring; X Allow sufficient space to install the refrigerator on a flat surface; X Allow clearance to the right, left, back and top when installing. This will help reduce power consumption and keep your energy bills lower. Clockwise rotate feet to heighten them by hand. Anticlockwise rotate feet to lower them by hand. positioning Install this appliance at a location where the ambient temperature corresponds to the climate class indicated on the rating plate of the appliance: -extended temperate (SN): `this refrigerating appliance is intended to be used at ambient temperatures ranging from 10 °C to 32 °C'; -temperate (N): `this refrigerating appliance is intended to be used at ambient temperatures ranging from 16 °C to 32 °C'; -subtropical (ST): `this refrigerating appliance is intended to be used at ambient temperatures ranging from 16 °C to 38 °C'; -tropical (T): `this refrigerating appliance is intended to be used at ambient temperatures ranging from 16 °C to 43 °C'; location The appliance should be installed well away from sources of heal such as radiators, boilers, direct sunlight etc. Ensure that air can circulate freely around the back of the cabinet. To ensure best performance, if the appliance is positioned below an overhanging wall unit, the minimum distance between the top of the cabinet and the wall unit must be at least 100 mm. Ideally, however, the appliance should not be positioned below overhanging wall units. Accurate leveling is ensured by one or more adjustable feet at the base of the cabinet, and the wall unit must be at least 100 mm. Ideally, however, the appliance should not be positioned below overhanging wall units. Accurate leveling is ensured by one or more adjustable feet at the base of the cabinet. It must be possible to disconnect the appliance from the mains power supply; the plug must therefore be easily accessible after installation. electrical connection Before plugging in, ensure that the voltage and frequency shown on the rating plate correspond to your domestic power supply. The power supply cable plug is provided with a contact for this purpose. [. . . ] Temperature is set too cold or the appliance runs at SUPER modes, Please look in the initial Temperature Setting section. For an extended only as long as The food is not A large quantity Turn the The appliance is Please look in the Near a heat Heavy build up of frost on the door seal. Carefully warm the leaking sections of the door seal with a hair dryer (on a cool setting) At the same time shape the warmed door seal by hand such that it sits correctly. Appliance is not Re-adjust the The appliance is Move the Out of the way If the malfunction shows again, contact the Service Center. [. . . ]