User manual CANDY CID 30/G3

[. . . ] Thank you for purchasing the CANDY induction hob. Please read this instruction manual carefully before using the hob and keep it in a safe place for future reference. On our own responsibility, compliance to all the European Safety, health and environmental requirements stated in the Please read this information before using your hob. Disconnect the appliance from the mains electricity supply before Carrying out any work or maintenance on it. [. . . ] Setting the timer to turn one cooking zone off 1. Touch the heating zone selection control that you want to set the timer for. Touch timer control, the minder indicator starts flashing and "10" is shown in the timer display. Set the time by touching the "-" or "+" control of the timer. Hint: Touch either the "-" or "+" control of the timer once, time decreases or increases by 1 minute. Touch and hold either the "-" or "+" control of the timer, time decreases or increases by 10 minutes. If the setting time exceeds 99 minutes, the timer will automatically return to 00 minute. Touching the "-" and "+" together, the timer is cancelled, and the "00" will be shown on the minute display. When the time is set, it will begin to count down immediately. The display will show the remaining time and the timer indicator will flash for 5 seconds. NOTE: The red dot next to power level indicator lights up indicating that zone is selected. When cooking timer expires, the corresponding cooking zone will be switched off automatically. Stir the ingredients gently to make sure they are heated through. The exact setting will depend on several factors, including your cookware and the amount you are cooking. Experiment with the induction hob to find the settings that best suit you. Delicate warming for small amounts of food · Melting chocolate, butter, and foods that burn quickly · Bringing soup to the boil · The settings below are guidelines only. The exact setting will depend on several factors, including your cookware and the amount you are cooking. Experiment with the hob to find the settings that best suit you. Everyday soiling on glass (fingerprints, marks, stains left by food or non-sugary spillovers on the glass) Switch the power to the hob off. Apply a cooktop cleaner while the glass is still warm (but not hot!Rinse and wipe dry with a clean cloth or paper towel. Switch the power to the cooktop back on. [. . . ] Use pans whose diameter of the ferromagnetic area (base of the pan) is in the range of dimensions in the table below. (Table 1) - If you use smaller pots, performance could be affected - If you use pot with a diameter smaller than the one indicated in the table 1, pots may not be detected According to the dimension of the zone you can use pots of different diameters as picture below: 5. If the ferromagnetic part covers only partially the base of the pan, only the ferromagnetic area will heat up, the rest of the base may not heat up a sufficient temperature for cooking. If the ferromagnetic area is not homogeneous, but presents others material such as aluminum this may affect the heating up and the pan detection. [. . . ]