User manual CANDY CIDC 61 X

[. . . ] if in doubt ask a qualified electrician. - If the power supply cable is damaged, it must be replaced with another cable or a special assembly, which may be obtained direct from the manufacturer or from the Technical Assistance Centre. A) Do not check the status of the filters while the cooker hood is operating B) Do not touch bulbs or adjacent areas, during or straight after prolonged use of the lighting installation. C) Flambè cooking is prohibited underneath the cooker hood D) Avoid free flame, as it is damaging for the filters and a fire hazard E) Constantly check food frying to avoid that the overheated oil may become a fire hazard F) Disconnect the electrical plug prior to any maintenance. [. . . ] Introduce the extraction assembly into the frame, ensuring that the screws O (loosened previously) hook into the slots as indicated in (Fig. - Take the upper duct L and fit it to the duct fixing bracket C using the 4 screws D (Fig. - For the filter version, once the duct is fixed to the frame the RHS and LHS deflectors E should be moved outwards, using the corresponding slots (Fig. 13) so that they are aligned with the air outlet screen of the hose. - Fix the air evacuation pipe H (not supplied) onto the connection flange F (Fig. 14) - Take the locking device N and join it to the upper duct, then fix it in place using the 4 screws Y (Fig. - Electrical connection Before connecting the appliance to the electricity supply, remove the 4 screws A, open the covers and perform the necessary electrical connections between the body of the cooker hood and the motor assembly (Fig. The effective performance of the cooker hood depends on constant maintenance; the anti-grease filter and the active carbon filter both require special attention. The anti-grease filter is used to trap any grease particles suspended in the air, therefore is subject to saturation (the time it takes for the filter to become saturated depends on the way in which the appliance is used). The acrylic filter, which is found resting on the grille, should be replaced when the text, visible through the grille, changes colour and the ink spreads; the new filter should be fitted in such a way that the text can be seen through the grille from outside the cooker hood. If the filters do not have any text on them, or if metal filters or aluminium panel filters are used, they should be washed every 2 months in order to prevent the risk of fire. To wash the filters, proceed as follows: - Remove the filter from the grille and wash it using a solution of water and neutral liquid detergent, leaving the dirt to soften. - Rinse thoroughly with warm water and leave to dry. the metal filters and/or aluminium panel are also dishwasher safe. If the filters are made using aluminium, or if an aluminium panel is used, after a few washes the colour may change. This does not mean they have to be replaced. If the replacement and washing instructions are not followed, the anti-grease filters may present a fire hazard. The active carbon filters are used to purify the air which is released back into the room. The filters are not washable or re-usable and must be replaced at least once every four months. The active carbon filter saturation level depends on the frequency with which the appliance is used, the type of cooking performed and the regularity with which the antigrease filters are cleaned. Remove build-up from the fan and other surfaces of the cooker hood regularly using a cloth moistened with denatured alcohol or non-abrasive neutral liquid detergent. The light on the cooker hood is designed for use during cooking and not for general room illumination. [. . . ] After ten minutes the motor switches off and the LED of key F remains switched on with a fixed light until the motor starts up again at the first speed after fifty minutes and keys F and C start to flash again for ten minutes and so on. By pressing any key for the exclusion of the hood light the hood will return immediately to its normal functioning (e. If key D is pressed the "clean air" function is deactivated and the motor moves to the 2nd speed straight away. Which will continue functioning for 15 minutes at the operating speed set at the time this function is activated. [. . . ]