User manual CANDY CIDT 61 X

[. . . ] Before connecting the model to the electricity network: - control the data plate (positioned inside the appliance) to ascertain that the voltage and power correspond to the network and the socket is suitable. if in doubt ask a qualified electrician. - If the power supply cable is damaged, it must be replaced with another cable or a special assembly, which may be obtained direct from the manufacturer or from the Technical Assistance Centre. [. . . ] Please note: To avoid scratching the upper duct, first adjust its height as desired, using the measurements given in (Fig. 6) as a reference, and then fix it in place using the 8 screws provided G (Fig. - Extractor hood: connect the flexible hose H (not supplied) to the air exhaust hole made previously and fix the hose to the connector flange F (Fig. - The active charcoal filters must be fitted to the extraction assembly located inside the cooker hood (Fig. Before proceeding with the installation process, open the panel by pressing on the point indicated in Fig. 2a; this will make the cooker hood easier to handle. If the product is supplied with active charcoal filters, remove them by pulling the lever outwards as indicated in Fig. Take the ducts out of the packaging (Fig. 10A) and separate the upper duct Y from the lower duct L. Remove the protective materials from the upper duct Y, as indicated in figure 10A. - Take the upper duct Y and fix it to the structure using the 2 screws X (Fig. Join the lower part of the cooker hood L to the upper duct Y until it clicks into place, then secure it in this position on the lower part of the cooker hood using the 4 screws A as indicated in figure 11. - Electrical connection Before performing this connection, loosen the 4 screws D on the two boxes and open the cover panels (Fig. - Perform the necessary electrical connections between the cooker hood body and the motor assembly (Fig. On constant maintenance; the anti-grease filter and the active carbon filter both require special attention. The anti-grease filter is used to trap any grease particles suspended in the air, therefore is subject to saturation (the time it takes for the filter to become saturated depends on the way in which the appliance is used). The acrylic filter, which is found resting on the grille, should be replaced when the text, visible through the grille, changes colour and the ink spreads; the new filter should be fitted in such a way that the text can be seen through the grille from outside the cooker hood. If the filters do not have any text on them, or if metal filters or aluminium panel filters are used, they should be washed every 2 months in order to prevent the risk of fire. [. . . ] By pressing any key for the exclusion of the hood light the hood will return immediately to its normal functioning (e. If key D is pressed the "clean air" function is deactivated and the motor moves to the 2nd speed straight away. by pressing key B the function is deactivated). [. . . ]