User manual CANDY CISD 94

[. . . ] In the Ducting version, cooking vapours and odours are conveyed straight outside by a disposal duct which passes through the ceiling (Fig. In the hoods with an outside motor (Fig. [. . . ] Adjust the height of the flues with the eight retaining screws (Fig. 9A) taking into account that the hood is 100 mm high and that the distance between the hood and the hob must be at least 650 mm (Fig. Take the flange with the metal valve (Fig. 11H) and assemble it onto the opening of the hood for air venting, pressing slightly. Now make the electrical connection A and connect the air exhaust pipe to the flange B holding the hood raised (Fig. Only for models with external motor (Fig. 13): connect the hood to the external motor using the special terminal block: remove wire clamp A and lid B from the wiring junction box; fix the connecting wire of the external motor to terminal C; then replace wire clamp A and lid B on the wiring junction box; the other end of the wire is secured to the terminal block on the external motor. Lift the island and rest it against the lower flue, then fix the parts with the eight screws provided (Fig. At this point the installation is complete and the anti-grease filters can be remounted. filtering version: After fitting the bracket to the ceiling , install the baffle (Fig. 15) with the four screws "A", fix the flange "B" with a rotating movement. arrange the power cable and the air exhaust pipe as shown in Figure 16. [. . . ] Replacing the charcoal filters: If the unit is a filtering hood, the charcoal filters must be replaced: to remove them press inward on the clamp (Fig. 19) and rotate the filter downward until the 2 tabs can be removed from the housing. [. . . ]