User manual CANDY CIVS 633

[. . . ] Do not store detergents or flammable meterials beneath the hob. If the surface of the hob is cracked, swith off the appliance to avoid the possibility of electric shocks. Do not place rough or uneven appliances, which may damage the ceramic surface. Clean the induction hob regularly to stop foreign objects from 2 getting into the fan and preventing the appliance from working properly. [. . . ] The default shutdown times are shown in the table below: Power level 1~3 4~6 7~9 The heating zone shut down automatically after 8 hours 4 hours 2 hours Installation 1. Cut a hole in the worktop of the dimension shown in the diagram below. A minimum of 50 mm space should be left around the hole. The worktop should be at least 30 mm thick and made of heat-resistant material. It is essential that the induction hob is well ventilated and that the air intake and exit are not blocked. Make sure the hob is correctly installed as shown in Figure 2. Figure (2) Air exit mini 3 cm mini 5 mm mini 2 cm When the pan is removed from the cooking zone, it stops heating immediately and switches itself off after the buzzer has sounded for one minute. Warning: Anyone who has been fitted with a heart pacemaker should consult a doctor before using the induction hotplate. 6 Air intake Figure (2) NB: For safety, the gap between the hob and any cupboard above it should be at least 760 mm. Fix the hob to the worktop using the four brackets on the base of the hob. The position of the brackets can be adjusted according to the thickness of the top. warnings: (1) The induction hob must be installed by a properly qualified person. Never try to install the appliance yourself. (2) The induction hob must not be installed above refrigerators, freezers, dishwashers or tumble dryers. (3) The induction hob should be installed so that optimum radiation of heat is possible. (4) The wall and the area above the hob should be able to withstand heat. (5) To avoid any damage, the sandwich layer and adhesive should be heat-resistant. Connection to power supply The socket should be connected in compliance with the relevant standard, to a single-pole circuit breaker. the method of connection is shown in Figure 3. If the cable is damaged or needs replacing, this should be done by an after-sales technician using the proper tools, so as to avoid any accidents. If the appliance is being connected directly to the mains supply, an omnipolar circuit breaker must be installed with a minimum gap of 3 mm between the contacts. The installer must ensure that the correct electrical connection has been made and that it complies with safety regulations. [. . . ] 6 Use pans whose diameter is as large as the graphic of the zone selected. Using a pot a slightly wider energy will be used at its maximum efficiency. If you use smaller pot efficiency could be less than expected. Pot less than 140 mm could be undetected by the hob. [. . . ]