User manual CANDY CM1 126

[. . . ] Before switching on the appliance make sure it is correctly installed and that the transit brackets are removed as shown in page 101. Note: pull out the mains plug from appliances which are finished with. Cut the power cable and dispose of it, together with the plug. When disposing of an old washing machine, please ensure that the porthole lock is rendered inoperable to prevent children shutting themselves in the appliance. [. . . ] By pressing this button, which can only be activated in the Cotton cycles, the sensors in the new Activa system come into operation. They affect both the selected temperature, keeping it at a constant level throughout the wash cycle, and the mechanical function of the drum. The drum is made to turn at two different speeds at crucial moments. When the detergent enters the garments, the drum rotates in such a way that the detergent is distributed in a uniform manner; during the wash and rinse procedures, however, the speed increases in order to maximise the cleaning action. Thanks to this special system, the efficiency of the wash procedure is improved WITHOUT ANY INCREASE IN THE LENGTH OF THE PROGRAM. On selecting the wash programme the display will inform you of the maximum spin speed permitted for that programme. by repeatedly pressing the select spin button the speed will decrease by increments of 100 rpm. The minimum speed permitted is 400 rpm, or by continuously pressing the select spin option the spin may be cancelled if desired. Note: this model is fitted with an electronic "sensor" device that checks the load is balanced correctly. If the load is slightly unbalanced the machine will re-balance it automatically to then carry out the normal spin. If, after several attempts, balance is not restored a reduced spin speed will be used. The machine is programmed to automatically take up additives during the final rinse stage for all wash cycles. SPECIAL "FAST SPIN" PROGRAMME Programme "FAST SPIN" carries out a maximum spin (which can be reduced by using the correct button). The washing machine is fitted with a self adjusting water level system. This system enables the machine to use the amount of water needed to wash and rinse the laundry in relation to the particular load. This results in a reduction of the water and electricity used, without in any way compromising the washing and rinsing performance. In fact the amount of water and electricity used will always be appropriate for the clothes load. To be able to wash together different type of fabrics (e. To wash with a considerable energy saving. The "Mix & Wash" programme has a temperature of 40°C and alternate dynamic phases (the basket that turns) to static phases (fabrics in soak in phase of rest) with a duration programme that almost reaching the 3 hours. The energy consumption for the complete cycle is only 850 W/h. important: · The first washing of new coloureds fabrics must be done separately; · In every case, never mix NON-FAST COLOUREDS fabrics. [. . . ] 2) Lean the machine forward and remove the plastic bags containing the two polystyrene blocks at the sides, pulling downwards. 3) Press the plug (to be found in the envelope with the instructions) into the hole. 5) Use front feet to level the machine with the floor. Load of dry laundry Water pressure A) Turn the nut clockwise to release the screw adjuster of the foot. [. . . ]