User manual CANDY CMD97

[. . . ] insert the screws and plugs provided (A). The unit is secured to the rear panel as though it were being installed on the wall: use the supplied metal bracket (B) and the screws and plugs supplied with the panel. Securing the extension pipes: Basic installation requirements: ­ Set the electrical power supply within the space covered by the decorative piping. ­ If your unit is installed in an Exhaust hood or in a hood with outside motor, prepare the air exhaust hole. [. . . ] When installing exhaust hoods and hoods with outside motor, to achieve the best possible conditions use an air exhaust pipe that : is as short as possible, has a minimum of curves (maximum angle: 90°), is made of a material that complies with the standards (which vary from nation to nation) and iv) is smooth on the inside. It is also advisable to avoid any drastic changes in pipe section (diameter: 150 mm). Adjust the width of the extension pipe support bracket (W) using screws A indicated in Fig. Make certain it is aligned with the hood. For exhaust hoods, turn the upper pipe over so that the air exhaust grid is in the lower section (Fig. Exhaust hoods and hoods with outside motors: Connect the hood flange to the exhaust hole in the wall/ceiling using a flexible pipe. Only for models with outside motor (Fig. 11): plug the hood into the outside control unit using the special terminal block: remove wire clamp A and lid B from the wiring junction box. The other end of the wire is secured to the terminal block on the outside control unit. Insert the extension pipes setting them on the hood; extend the upper pipe to the ceiling and secure with the 2 screws (G) - Fig. Button E: drives the motor in fourth speed (the corresponding pilot lamp comes on); when pressing the button a second time (while the pilot lamp is on) , the TIMER is activated and thus the motor stops after 5' (the pilot lamp flashes). Pay special attention to the anti-grease filters: if the model purchased has the commands shown in Figure 16: the antigrease filters must be cleaned approximately once every 30 hours of operation (when the central segment on the display goes on or starts blinking). to remove the filters: press inward on the clamps at the handles and pull the filter downward. Wash out the filter by hand or in the dishwasher using a neutral soap. Once the cleaned filters are reinstalled, keep button R (Reset) pressed for two seconds to reset the counter. If the model purchased has the commands shown in Figure 17: the grease filter must be replaced periodically: exactly how often depends on use (at least once every other month). To remove the filter: push inward on the clamp at the handle and pull the filter downward. Wash out the filter by hand or in the dishwasher using a neutral soap. If the model purchased has the commands shown in Figure 18: the anti-grease filters must be cleaned approximately once every 30 hours of operation (when the light button lamp comes on) - Fig. Wash out the filter by hand or in the dishwasher using a neutral soap. [. . . ] If the model purchased has the commands shown in Figure 18: the anti-grease filters must be cleaned approximately once every 30 hours of operation (when the light button lamp comes on) - Fig. Wash out the filter by hand or in the dishwasher using a neutral soap. Once the cleaned filters are reinstalled, to reset the counter hold the light button pressed down for about 1" (Fig. Replacing the charcoal filters: If the unit is a filtering hood, the charcoal filters must be replaced: to remove them press inward on the clamp (Fig. [. . . ]