User manual CANDY CRU164

[. . . ] On completion of installation, check that the appliance is not standing on the power cable. The appliance should be left for 2 hours after installation before it is turned on, in order to allow the refrigerant to settle. This appliance is designed for domestic use only, specifically for the storage of edible foodstuffs only. During the normal operation, the condenser and compressor located at the rear of the appliance can reach higher temperatures; ensure that installation is carried out according to the instructions in this booklet. [. . . ] Simply remove by hand and dispose of as recyclable plastic material. INSTALLATION Positioning Position the appliance away from sources of heat such as stoves, radiators, direct sunlight etc. Maximum performance and safety are guaranteed by maintaining the correct indoor temperature for the class of unit concerned, as specified on the rating plate. Climate classification SN N ST T Ambient temperature 10~32 16~32 16~38 16~43 Appliances must not be exposed to rain. Sufficient air must be allowed to circulate in the lower rear section of appliances, as poor air circulation can affect performance. Built-in appliances should be positioned away from heat sources such as heaters and direct sunlight. Electrical connection Before connecting the appliance to the power supply, ensure that the voltage and frequency as indicated on the data plate correspond to those of the electrical mains. A deviation of ­6V to +6V is admissible with respect to the rated voltage. For operation with other voltage supplies, a right autotransformer is required. Always connect the appliance to an useful earthing system For the above, if the main supply is not earthed, connect the appliance to a separate earthing system. Consult a specialized technician to carry out the latter in compliance with current standards. The manufacturer declines all responsibility for failure to observe the above accident prevention standards. 4 Cleaning the interior prior to use Prior to use, clean all internal parts with warm water and neutral detergent to remove the "new" odor and dry thoroughly. Never use abrasive detergents and/or powders that can damage the appliance. Installation instructions: Before installing, carefully read the instruction in order to avoid a certain number of problems. Fig 2 -Dimensions of mounting slot Fig 3 -Height regulation Fig 4 -Installation of the appliance under the worktop Fig 5 -Fastening the appliance under the worktop Fig 6 -Door exchange Fig 7, Fig 8 ­Mounting the kitchen cabinet door 5 6 7 6 8 7 8 9 View of the appliance Freezer Chamber IceTray Rack Cover Upper rack on the door Temperature Regulator Shelf Lower rack on the door Crisper Drawer Cover Crisper Drawer How to remove the shelf from the appliance The shelf may be placed randomly upon any of the guide slots inside the appliance. In case you want to adjust the shelves or remove the shelves from the appliance. 1Lift the shelf by hand and pull it towards you until it reaches the crack in the guide slot. 2Lift the shelf up and pull it out inclined between the door and appliance. Reinsertion is carried out in the opposite procedure. 10 Changing over the freezer compartment door Open the freezer compartment door a little way Using a small screwdriver, press the spring in the opening of the lower door bearing slightly upwards and take the door bearing out complete with the door. Position the covering cap (M) on the opposite side Turn the freezer compartment door through 180 and fit the lower door bearing into the lower bearing cavity of the freezer compartment door. [. . . ] The water from the thawing frost evaporates by itself. low Adjust the thermostat to give correct temperature control. The compressor runs Large quantities of food have recently been placed in the continuously cabinet / and or door is frequently opened. Check that air ventilation is not obstructed. [. . . ]