User manual CANDY CSF4552X

[. . . ] We are confident it will assist you loyally in washing your daily dishes in full safety. Carefully read this manual for correct and safe appliance use and for helpful tips on efficient maintenance. Only use the dish washer after carefully reading these instructions. We recommend you always keep this manual to hand and in good condition for any future owner. [. . . ] 3) when you have finished, refit the rotor arms in the same position, remembering to re-align the arrow and screw into position. L Both the door lining and the tank lining are in stainless steel; however, should spots caused by oxidation occur, this is probably due to a high level of iron salts presents in the water. L The spots can be removed with a mild abrasive agent; never use chlorine based materials, steel wool, etc. L If, in spite of the routine cleaning of the filters, you notice that the dishes or pans are not properly washed or rinsed, check that all the spray heads on the rotor arms (fig. If they are blocked, clean them in the 1) to remove the upper rotor arm, turn it until it lines up with the stop marked by the arrow (fig. 1) and, keeping it pushed in, unscrew it in a clockwise direction (to reassemble it repeat the same operation, but turn it anticlockwise). The lower rotor arm can be removed simply by pulling it upwards (fig. 2); 2) wash the rotor arms under a jet of water to clear any blockage in the spray heads. After every wash it is essential to turn off water supply and to switch off the machine by pressing the On/Off button to the off position. If the machine is not going to be used for some time, it is advisable to follow these rules: 1. Do an empty wash with detergent in order to clean the machine of any deposits; 2. Turn off the water tap; Keep the inside of the machine clean; 7. If the machine is left in places where the temperature is below 0°C any water left inside the pipes may freeze. Wait until the temperature rises above zero and then wait for about 24 hours before. A ON/OFF Button B "PROGRAMME SELECTION" button/ENROLMENT Wi-Fi C "Start/Reset" button (start/cancel programme) D "EXPRESS" option button E "START DELAY" button F "Reset" button for "SALT EMPTY" light G "RINSE AID EMPTY" light H "PROGRAMME STATUS" lights/"DELAY START" time lights I "DELAY START" time lights L "PROGRAMME SELECTION" light M "Addish" light Place settings (EN 50242) Capacity with pans and dishes Water supply pressure (MPa) PROGRAMME SELECTION Next time you switch on the AND SPECIAL FEATURES appliance L To turn the appliance on and off, press the ON/OFF button (for at least 3 seconds). L Hold down the ON/OFF button for about 3 sec. To turn the machine on, and the "P3"programme indicator light will come on. At the end of the cycle, remember to switch off the appliance using the ON/OFF button, then remove the plug and close the water supply. If you have turned on the programme memorisation function, the indicator light corresponding to the last programme completed will appear on the display. First time you switch on the appliance L Connect the machine to the power supply. L Open the door, put the dishes to be washed inside, and close the door again. L Press the "ON/OFF" button and hold for about 3 seconds. [. . . ] After checking to make sure the water supply is open, that the drain pipe is not bent and that the siphon or filters are not clogged, set the selected program again. If the fault persists, contact the Technical Assistance Centre. This dishwasher is equipped with an overflow safety device that, in the event of a problem, automatically discharges any excess water. To ensure the correct operation of the overflow safety device, we recommend not moving or tilting the dishwasher during operation. [. . . ]