User manual CANDY CST-110 EX

[. . . ] Remove the machine from its packaging close to the final location of the machine. Cut carefully around the base of the packaging and up one corner. Make sure it is out of the reach of children, it is a potential source of danger. If damaged do not use and please call GIAS Service. [. . . ] You may be charged for a service call if a problem with your machine is caused by incorrect installation. Tumble dryers are supplied to operate at a voltage of 230V, 50 Hz single phase. The plug should be accessible for disconnection after the appliance has been installed. If the mains cord on this appliance is damaged, it must be replaced by a special cord which is ONLY obtainable from the spares service. The wires in the mains lead are coloured in accordance with the following codes: Blue Brown Green and Yellow NEUTRAL LIVE EARTH Do not plug the machine in and switch it on at the mains until the installation is completed. For your safety, this dryer must be correctly installed. If there is any doubt about installation, call GIAS Service for advice. Once the machine is in place the feet should be adjusted to ensure that the machine is level. Adequate ventilation must be provided in the room where the tumble dryer is located to prevent gases from appliances burning other fuels, including open fires, being drawn into the room during operation of the tumble dryer. Exhaust air must not be discharged into a flue which is used for exhausting fumes from appliances burning gas or other fuels. Check regularly that the air flowing through the dryer is not restricted. Put dripping wet items into the tumble dryer, this may damage the appliance. The table shows approximate drying times, depending on the type of fabric and dampness of the clothes. Press for 5 seconds to cancel/reset the programme `Séchage Délicat' button ­ Press to reduce the heat level for delicate items, the indicator above the button will light up. To change the heat setting the programme must be reset Low Heat ­ Indicator light ON High Heat ­ Indicator light OFF `Plein' indicator ­ lights when the water container is full `Filtre' indicator ­ lights when the filter needs cleaning `Départ Différé' button ­ Allows the user to delay the start of the drying cycle (see details of operation page 16) `Départ Différé' Display START ­ When the dryer is switched On the START indicator will flash, when the programme starts the START indicator will light up 60' ­ Indicator lights when there is less than 60 minutes left until completion of the programme 15' ­ Indicator lights when there is less than 15 minutes left until completion of the programme. At this stage of the drying cycle the machine enters the Cool Down phase STOP ­ Indicator lights when the programme is finished. 6h ­ 6 hour start delay (light flashes when in operation) 9h ­ 9 hour start delay (light flashes when in operation) When the tumble dryer is in use the drum and door may be VERY HOT. Never stop a tumble dryer before the end of the drying cycle unless all items are quickly removed and spread out so that the heat is dissipated. Gently remove lint using a soft brush or your fingertips. Snap the filter together and push back into place. `Filtre' lights when the filter needs cleaning. If the laundry is not drying check that the filter is not clogged. [. . . ] programme Drying (A ranger) Iron Dry (Prêt à repasser) Wool (Laine) Description Select the degree of dryness that you require. This ranges from for bath towels and bathrobes, through for items that will be put away without ironing, to the programme that leaves the laundry suitable for ironing. A gentle programme specially created to get woollens softer after air-drying. This delicate warm air cycle, lasting 12 minutes, can also be used to get woollens 'refreshed' after being stored in the wardrobe. [. . . ]