User manual CANDY CT-502

[. . . ] This appliance is intended solely for domestic use and is designed for the following functions: cooking and reheating food. Any other use is considered as improper. Check that the appliance has not been damaged during transport; Keep all packaging materials (plastic bags, polystyrene foam, nylon, etc. ) away from children, as they are potentially dangerous. [. . . ] Pressing the power supply button at the same time as other keys has no effect and the touch control remains in standby status. The touch control can be switched off at any time using the power supply button. This is also the case if the control has been locked with the child safety feature. The power supply button always has highest priority for shutdown. With the touch control on, select a cooking zone by pressing the selection key. When the respective display shows a "0", the plate is ready. if the area is hot an H will be shown on the display for the corresponding plate. By pressing the key "+" you can select a power level and the zone will start heating up. Starting from level 1, it is increased by one every 0. Upon reaching level 9 you cannot make any further increases. If the cooking zone is selected using the "-" key, the initial level is 9 (the highest level available). After switching off the control unit the child lock is reactivated. For de-active the lock function definitely, press the cooking zone select key and the minus key simultaneously followed by pressing only the minus key again. After carrying out all steps in the correct order and within a period of 10 sec, the locking is cancelled and the control unit is in a STAND-BY mode. If the control unit is switched on again by pressing the ON/OFF key, all displays show "0", the display dots keep flashing and the control unit may be operated for cooking. ; a sound will signal when time has expired This is available only when you are not using the hob. If the touch control is off, the autonomous timer can be used by activating the timer key. If you activate the on key, the touch control goes back to standby status and the timer is shut off. ), can be carried out in increments of one minute with any of the PLUS buttons from 0 to 99 and with the MINUS button from 99 to 0. Continuous activation of PLUS or MINUS provide dynamic increase of the speed of variation up to a maximum value, with no sound signals. If the PLUS (or MINUS) key is released, the speed of increase (or decrease) goes back to its original value. The timer can be set both with continuous activation of the PLUS and MINUS keys and with continuous activation in subsequent touches (with sound signal). [. . . ] When the control panel detects an ambient temperature greater than 95°C (+- 5%) it shuts off the elements. A heating element that is shut off by the thermal protection can be turned on only when the temperature drops below 95°C. These instructions are intended for qualified technicians. The appliance must be installed correctly, in compliance with current laws. [. . . ]