User manual CANDY DFI 85 S (41003716.B)MOD-1

[. . . ] EN User instructions DFI 85 S Congratulations!Thank you for choosing a Candy appliance; quality dishwashers which guarantee high performance and reliability. Candy manufacture a vast range of domestic appliances: washing machines, washer/dryers, cookers, microwave ovens, ovens and hobs, refrigerators and freezers. Ask your dealer for the catalogue with the complete range of Candy products. [. . . ] After pouring the detergent into the container close the lid. Since not all detergents are the same the instructions on the boxes of detergent can vary. We should just like to remind users that too little detergent does not clean the dishes properly whilst too much detergent will not produce better results and is also a waste. Do not use an excessive amount of detergent and help to limit damage to the environment at the same time. Wash with soaking cycle If setting the Intensive wash programme, a second dose of about 20 gr of detergent (1 table-spoon) must be added to the machine in the prewash section of detergent compartment (2). This dose should be placed directly in the prewash section of detergent compartment (2). 14 15 If you select a programme with a prewash cycle, the performance will be improved by adding a small amount of detergent during this part of the cycle. IMPORTANT NOTE ON THE USE OF COMBINED DETERGENTS If you are planning to use combined detergents i. e. those with built in salt and/or rinse agent, we would advise the following: - read carefully and follow the manufacturer's instructions given on the packaging; - some combined detergents, particularly those with built in rinse agent, provide best results when used with specific programmes; - the effectiveness of detergents containing the built in water softener/salt depends on the hardness of your water supply. Check that the hardness of your water supply is within the effective range given on the detergent packaging. In certain circumstances use of combined detergents can cause: - limescale deposits on dishes or in the dishwasher; - a reduction in washing and drying performance. Should this occur, we would recommend using traditional separate products ­ salt, detergent and rinse agent. This will ensure that the water softener in the dishwasher operates correctly. Please note that on return to the use of conventional salt, a number of cycles will be required before the system becomes fully efficient again. NOTE Any problems which arise as a direct result of the use of these products are not covered by our warranty. Cleaning the filters 1 The filter system (fig. A "4") consists of: a central container that traps the larger particles. a flat gauze that continuously filters the wash water a micro filter, located beneath the gauze, that traps the tiniest particles ensuring a perfect rinse. To achieve excellent results every time, the filters should be checked and cleaned after each wash. To remove the filter unit, simply turn the handle anticlockwise (fig. For ease of cleaning, the central container is removable (fig. Remove the gauze filter (fig. 3) and wash the whole unit under a jet of water. With the Self-cleaning Micro filter, maintenance is reduced and the filter unit need only be checked every two weeks. Nevertheless, after each wash it is advisable to check that the central container and the gauze filter are not clogged. NB: after cleaning the filters, make sure that they are correctly reassembled and that the gauze filter is properly positioned at the bottom of the dishwasher. [. . . ] Wash load of 4/6 persons. 50°C 130 YES Rapid 32 minute programme 40°C 32 Cold pre-wash Short cold pre-wash for items that are stored in the dishwasher until you are ready to wash a full load. 6 24 Economy button Check rinse aid dispenser With cold water (15°C) Programme Description Second cold rinse First cold rinse Cold pre-wash Hot pre-wash Hot rinse with rinse aid Detergent for washing Clean filter Main wash Identifying minor faults Warning!Should the dishwasher fail to operate, before contacting the Service Centre, make the following checks: FAULT CAUSE Plug is not connected to wall socket 1 - Machine completely dead O/I button has not been pressed Door is open No electricity See causes for no. 1 Water tap is turned off 2 - Machine does not draw water Programme selector is not at correct position The inlet hose is bent The inlet hose filter is not correctly connected Filter is dirty Outlet hose is kinked 3 - Machine does not discharge water The outlet hose extension is not correctly connected The outlet connection on the wall is pointing downwards not upwards 4 - Machine discharges water continuously Position of outlet hose is too low Excessive amount of detergent 5 - Spray arms are not heard to rotate 6 - On electronic appliances without a display: "eco"indicator light and indicator light "No. 1" with audible signal are heard. 7 - On electronic appliances with a display: "E1" appears on the display with audible signal. [. . . ]