User manual CANDY DUO609X

[. . . ] RECOMMENDATIONS READ THE INSTRUCTIONS CAREFULLY TO MAKE THE MOST OF YOUR APPLIANCE. We recommend you keep the instructions for installation and use for later reference, and before installing the appliance, note its serial number below in case you need to get help from the after sales service. Identification plate is located at the back of the Duo. THE COMPANY SHALL NOT BE LIABLE IF THE INSTRUCTIONS PROVIDED IN THIS DOCUMENT ARE NOT COMPLIED WITH. SAFETY INSTRUCTIONS You should entrust the electrical connection of your appliance to an approved installer or technician with similar qualifications. The DUO consists of two elements an oven and a diswasher. [. . . ] CORRECT PRE-HEATING IS THE BASIS OF SUCCESSFUL RED MEAT COOKERY. CAKE - PASTRIES AND BISCUITS : Avoid using shiny moulds because they reflect heat and can spoil your cakes. Setting a programme Open the door and press the On/off button ; the 4 Program selection LEDs start flashing. - Set the required programme by pressing Programme selection button, LED of the chosen programme will turn on (2 LEDs for COLD RINSE programme). - Close the door (after audible signal), the chosen programme will start automatically. USE THE DISHWASHER Opening the door Grip the handle in the front panel and pull forward. If the machine comes open while it is working, an electrical safety device automatically switches everything off. For the machine to work properly, the door should not be opened while it is in operation. Closing the door Place the basket in the dishwasher. Make sure that the spray arm is free to rotate and is not obstructed by cutlery, crockery or pans. Close the door, pressing on it to make sure it is firmly shut. Interrupting a programme lt is not recommended that the door be opened while a programme is running, and especially not during the main wash phase and final drying. However, the appliance stops automatically when the door is opened. When the door is closed again, the programme continues automatically. If you wish to change or cancel a programme that is running, carry out the following procedure: . open the door, keeping the Programme selection button "P" pressed in until all 4 indicator lights are flashing. Before starting a new programme, you should check that there is still detergent in the dispenser. WARNING: if the door is opened during the drying phase, an intermittent audible signal is activated to advise that the cycle is not yet completed. End of programme The end of the programme is indicated by an audible signal. When the door is opened the programme selection indicator lights start flashing. Deactivating the audible signal The audible function can be deactivated in the following way: - press the On / Off button, - wait till the programme LEDs blink, - within 2 minutes, press and keep pressed for at least 30 seconds the Programme Selection button (the programme LEDs will still blink and an intermittent audible signal is heard). - Once the first two LEDs on the left are illuminated without blinking and the audible signal is off, release the button (the audible signal function is active). - Press again the Programme Selection button, the first two LEDs on the left will go off and the other two LEDs will turn on (the audible signal function is deactivated). [. . . ] Therefore, it is advisable to raise the temperature above 0°C, approximately 24 hours before using the machine again. CLEANING · Before carrying out any cleaning, you must : · Disconnect the appliance from the electrical supply and wait for all the hot parts to cool. · Never use abrasive cleaners, wire wool or sharp objects to clean the appliance. · OVEN LIGHTING The bulb and its cover are made of material resistant to high temperatures: 230 V~ - E 14 base - 15 W - Temperature 300°C mini. Replacing the bulb : disconnect the power supply from the oven before attempting to replace the lamp. [. . . ]