User manual CANDY FS 828 ZEN

[. . . ] Read the instructions carefully to make the most of your oven. We recommend you keep the instructions for installation and use for later reference, and before installing the oven, note its serial number below in case you need to get help from the after-sales service. When you have unpacked the oven, make sure that it has not been damaged in any way. If you have any doubts at all, do not use it: contact a professionally qualified person. [. . . ] PRELIMINARY CLEANING - clean the oven before using for the first time: . Wipe over external surfaces with a damp soft cloth. Wash all accessories and wipe inside the oven with a solution of hot water and washing up liquid. Set the empty oven to the maximum temperature and leave on for about 1 hour, this will remove any lingering smells of newness. Ensure that the room is well ventilated while this is being done. Stopping the oven: this may be necessary if you have input an incorrect instruction. Child safety device: To lock the oven controls, select the child safety device. refer to the section entitled "Programming - The child safety device". The cooling fan: this protects the control panel and electronics from heat damage. It begins and then stops automatically even when the oven is switched off. Oven lighting: By turning to the light symbol, you can switch on the oven light when it is not in use. When the oven is in use, the light stays on during all of the oven functions and when the door is opened. 3-The hours will then flash, set with the central button by turning to the "-" or "+", confirm by pressing the central button. 4-Turn back the control to the STOP position, the new hour is set. LANGUAGE CHOICE The pre-set language setting on the display panel is in Italian, but it can be changed. To change the language display, carry out the following procedure : 1- Turn the programme selector knob to "Light" symbol. Turn the button until the required language appears and confirm by pressing the same button. Turn the programme selector knob back to the STOP position. CLOCK SETTING When the oven is connected to the electricity supply or after a long power cut, the clock must be re-set. MANUAL MODE: direct access to "cooking" function modes, 7 choices are offered with a pre-programmed temperature range. DEFROST MODE:for defrosting the food before a cooking PIZZA MODE AUTO MODE: 5 types of the dish are recorded. Each menu suggests different recipes with preprogrammed data (quantity, temperature and cooking time). [. . . ] If you do not do this, the Cooking time and STOP symbols will continue flashing. PROGRAMMING THE END OF COOKING TIME: various recipes are pre-programmed with a cooking time and therefore with an end of cooking time. A pre-programmed end of cooking time for the various recipes will appear, or 00:00 for other oven functions or the time of day will be shown. Turn the central button to indicate the required number of minutes, and confirm your choice by pressing the same button. [. . . ]