User manual CANDY GCH990 NA1T

[. . . ] ικα Deutsch Dutch Deutsch Español 2 50 14 62 26 74 38 50 62 74 INDEX Introduction Delivery Information Unpacking the Product Safety Reminders Use Installation The Laundry Environmental Issues Gias Service Installation Electrical Requirements Adjusting the Feet Ventilation Drain Hose Kit: Fitting Instructions Preparing the Load Clothes Preparation Do Not Tumble Dry Energy Saving Sorting the Load Controls and Indicators Selecting the Programme Door and Filter Opening the Door Filter Filter Care Indicator To Clean the Condenser Filter Water Container To Remove the Container Operation Delay Start Function Cancelling and Resetting the Programme Cleaning and Routine Maintenance Cleaning the Dryer Technical Specifications Troubleshooting Customer Service Spares Gias Service 3 3 3 3 3 4 4 4 4 5 5 5 5 6 7 7 7 7 7 8 9 10 10 10 10 10 11 11 11 12 12 12 12 12 13 13 13 13 EN 2 INTRODUCTION Please read and follow these instructions carefully and operate the machine accordingly. This booklet provides important guidelines for safe use, installation, maintenance and some useful advice for best results when using your machine. Keep all documentation in a safe place for future reference or for any future owners. Delivery Information Please check that the following items are delivered with the appliance: Instruction manual Guarantee card Energy label Check that no damage has occurred to the machine during transit. [. . . ] The drier the laundry the shorter the drying time thus saving electricity. ALWAYS Try to dry the maximum weight of laundry, this will save time and electricity. Check that the filter is clean before every drying cycle. SELECTING THE PROGRAMME This machine has a special Sensor Dry to help you choose your preferred programme simply by selecting the level of dryness wanted. For small loads and pre-dried clothes, please use a Timing programme and select “Delicate fabrics” button to lower the temperature inside the drum. If the Sensor does not detect any item, this Dryer will work for only 10 minutes before starting the Cool down phase. If the load is too big or too wet, this Dryer will automatically work for 3 hours and then start the Cool down phase. At the end of each programme, there is always the Cool Down phase: it is a cool-air refresh phase of around 15 minutes. EN 8 SELECTING THE PROGRAMME PROGRAMME Perfect Home IDEAL FOR Clothes you want completely dryed, e. Store Dry Clothes you want to fold and store without ironing, e. Clothes you don’t need to iron, but just hang after the drying cycle. Leave clothes slightly damp to allow easier ironing. Good for items of clothing which have been left prior to ironing or if they have been dried outside or on radiators. This programme has a specific Anti-Crease function that relaxes fibres and makes easier ironing. Hang Dry Iron Dry No Crease Wool To soften your woollen clothes or to simply refresh them after a long time in the wardrobe. Mix & Dry To dry mixed cotton and synthetic clothes: save time and no need to separate the washing and dry them in different cycles. Shirts To dry shirts both cotton and synthetic fabrics. Time: 1h for 2kg of synthetic shirts (around 10 shirts); 1h and 20 min for 3 kg of cotton shirts (around 10 shirts). For dry, refreshed and ready to dress clothes in onyl 40 minutes. Sensor system keeps under control the temperature to have always the best result. If you want to choose drying times, from 30 to 180 minutes. By selecting “20 min” you choose a “cool programme”, ideal to refresh clothes and to remove eventual smells. [. . . ] check using another appliance such as a table lamp. Is the plug properly connected to the mains supply?Is the dryer switched on, both at the mains supply and at the machine?Has the drying time or the programme been selected? [. . . ]