User manual CANDY GVSH9A2TCEX

[. . . ] ES PT NL IT DE FR EN Please read and follow these instructions carefully and operate the machine accordingly. This booklet provides important guidelines for safe use, installation, maintenance and some useful advice for best results when using your machine. Keep all documentation in a safe place for future reference or for any future owners. Please check that the following items are delivered with the appliance: ● Instruction manual ● Guarantee card ● Energy label Index 1. [. . . ] Remove the sponge gently from its place and then wash the sponge by holding it 3 under a running tap turning it so to remove any dust or fluff. Refit the front cover ensuring it is in the correct way (as indicated by the arrow) and pushed firmly into 4 place. Lock the two levers by turning them clockwise 2 Filter Care Indicator Lights when the filter needs cleaning. If the laundry is not drying check that the filter is not clogged. If you open the door mid cycle, before the cool-down cycle has completed, the handle may be hot. Please use extreme caution when attempting to empty the water reservoir during the cycle. 5 Clean the filters before every cycle Please pay attention that overloading or bulky load can lead to door opening, in this case please reduce the load capacity to continue the drying cycle. CONTROLS AND INDICATORS Opening of the porthole with delayed start set, after re-closing the porthole, press start again to resume the counting. Drying Selection Button It allows to set the desired dryness level editable option up to 5 minutes after the starting of the cycle: - Ready to Iron : It leaves the garments slightly wet to facilitate ironing. - Dry Hanger : To get garment ready to be hang - Dry wardrobe : For laundry that can be directly stored -Extra-dry : To get completely dry garments, ideal for full load. This appliances is equipped with Drying Manager Function. On automatic cycles, each level of intermediate drying, prior to the reaching the selected one, is indicated by flashing the light indicator corresponding to the degree of drying reached In case of incompatibility, all LEDs flash quickly for 3 times. Rapids Button It's possible switch an automatic program to RAPID program, up to 3 minutes after the start of the cycle. The progressive pressure increases the time (30-45-59 minutes). After this selection to reset the automatic dying functioning is necessary to switch off the dryer In case of incompatibility, all LEDs flash quickly for 3 times. Anti crease This option allows to activate an anti-creases movement of the drum pre cycle in case of activation of the delay and at the end of drying cycle. It is activated every 10 minutes, up to 6 hours after the end of the drying cycle. To stop the movements set the knob to OFF. Useful when it's not possible to remove immediately. Keylock This function allows to block unwanted changes of the set options on the bezel , during drying phase. Activation/ Inactivation: Push 4 and 5 buttons simultaneously for two seconds . The sign "LOC" appears on the display. [. . . ] The dryer does not operate… ● Is there a working electricity supply to the dryer? check using another appliance such as a table lamp. — Is the plug properly connected to the mains supply?— Is the dryer switched on, both at the mains supply and at the machine? [. . . ]