User manual CANDY HCF3C7LFX

[. . . ] We are proud to offer the ideal product for you and the best complete range of home appliances for your daily routine. Carefully read this manual for correct and safe appliance use and for helpful tips on efficient maintenance. Only use the dish washer after carefully reading these instructions. We recommend you always keep this manual to hand and in good condition for any future owner. [. . . ] If the machine is not going to be used for some time, it is advisable to follow these rules: 1. Do an empty wash with detergent in order to clean the machine of any deposits; 2. Turn off the water tap; Keep the inside of the machine clean; 7. If the machine is left in places where the temperature is below 0°C any water left inside the pipes may freeze. Wait until the temperature rises above zero and then wait for about 24 hours before. A ON/OFF button B "PROGRAMME SELECTION" button/ENROLMENT Wi-Fi C "SMART DOOR" option button D C+E CHILD LOCK E "DELAY START" button F Reset" button for "SALT EMPTY" light G "START/RESET" button H "SALT EMPTY" light I "PROGRAMME STATUS" lights/"DELAY START" time lights L "SMART DOOR" light M "PROGRAMME SELECTION" light N "ADDISH" light Place settings (EN 50242) Capacity with pans and dishes Water supply pressure (MPa) PROGRAMME SELECTION Next time you switch on the AND SPECIAL FEATURES appliance L To turn the appliance on and off, press the ON/OFF button (for at least 3 seconds). At the end of the cycle, remember to switch off the appliance using the ON/OFF button, then remove the plug and close the water supply. Hold down the ON/OFF button for about 3 sec. To turn the machine on, and the "P3"programme indicator light will come on. First time you switch on the appliance L Connect the machine to the power supply. L Open the door, put the dishes to be washed inside, and close the door again. L Press the "ON/OFF" button and hold for about 3 seconds. L At this time only the "ON/OFF" and "PROGRAMME SELECTION" buttons will be active, and all the programme indicator lights will come on for 3 sec. After this only indicator light "P3" will stay on, and all the buttons will still be active. l Choose a programme with the "PROGRAMME SELECTION" button. L If you wish to select an option, press the corresponding button (the indicator light representing the selected option will come on). L Press "START/RESET" and a signal will sound, the indicator light corresponding to the selected programme will stay on and the wash indicator light will come on. From the Settings menu, you can adjust various parameters to suit your washing requirements. Entering the Settings menu l Turn on the dishwasher by holding the "ON/OFF" button down for about 3 sec. L Hold down the "PROGRAMME SELECTION" and "ON/OFF" buttons for about 5 sec. L All the indicator lights will flash for 5 sec. l The settings will be displayed: - Lime scale prevention settings appear when the indicator light comes on in the corresponding programmes. [. . . ] This dishwasher is equipped with an overflow safety device that, in the event of a problem, automatically discharges any excess water. To ensure the correct operation of the overflow safety device, we recommend not moving or tilting the dishwasher during operation. Should it be necessary to tilt or move the dishwasher, please ensure that the washing cycle is complete and that no water remains inside the appliance. Dishwasher does not fill with water Plug not connected to wall socket O/I button not pressed Door is open no electricity See point 1 The water tap is closed The water supply hose is bent The filter of the water supply hose is clogged Filter is dirty Drain pipe is bent The drain pipe extension is not correctly connected The outlet connection on the wall is pointing downwards not upwards Position of the drain pipe is too low SOLUTION Connect electric plug Press button Close door Check Check Open the water tap Eliminate the bends in the hose Clean the filter at the end of the hose Clean filter Eliminate the bends in the pipe Follow the instructions for connecting the drain pipe carefully call a qualified technician Lift drain pipe to at least 40 cm above floor level On electronic appliances without a display: one or more indicator lights flashing quickly The dishes are not completely dry Item prevents arms from rotating Filtering plate and filter very dirty Turn on the tap. [. . . ]