User manual CANDY PDV 32 C

[. . . ] It must be kept intact and within easy reach during the entire life of the cooktop. Please carefully read this manual and all the instructions contained herein before using the appliance. Keep any spare parts supplied with the appliance. Installation and electrical connections must be carried out by a qualified technician in accordance with the manufacturer's instructions and in full compliance with current laws and safety regulations. [. . . ] if the area is hot an H will be shown on the display for the corresponding plate. By pressing the key "+" you can select a power level and the zone will start heating up. Starting from level 1, it is increased by one every 0. Upon reaching level 9 you cannot make any further increases. If the cooking zone is selected using the "-" key, the initial level is 9 (the highest level available). If you hold down the key, the active level decreases. When you reach 1 you cannot decrease it any further. Use the "+" or "-" keys for change settings. A cooking zone can be switched off in the following way: By pressing the + and the - keys of the desired cooking zone simultaneously By selecting cooking zone 0 for the desired cooking zone by pressing the - key. All cooking zones can be switched off immediately, at any moment, by pressing the power button. When the automatic heating function has been activated, the power of the cooking zone reaches 100% for an established heating time, which depends on the selected power level. At the end of this heating time, the touch control returns to the pre-selected power level. Procedure to start automatic heating: - The control unit is switched on and a cooking zone is selected; - After setting cooking stage "9" automatic heating is activated by pressing the "+" key again. immediately afterwards , a "A" appears on the display. Once the parboiling boost has ended, only the selected cooking stage is indicated on the display. Using the "minus" key you can de-activate the function at any time. Based on the power level, each cooking zone is shut off after a maximum preset time if no operations are performed. Each operation with the cooking zone (using the PLUS or MINUS keys, or the dual circuit in the zone where present) resets the maximum operation time to its initial value. When the control is on, the ON/OFF key has priority over all other keys, so that the control can be shut off at any time, even in the event of multiple or continuous activation of keys. In standby mode, continuous activation of keys will not have any effect. However, before the electronic control can be turned back on, it must recognize that no key is activated. Otherwise, to lock press the cooking zone select key and the minus key simultaneously followed by pressing the cooking zone select key again. [. . . ] When the selection is modified from one zone to another, the timer display shows the timer value associated with that zone. The timers programmed for each cooking zone remain active nonetheless. in other ways the timer behaves in the same manner as the autonomous timer. To increase the value, the PLUS key for the corresponding cooking zone must be used. [. . . ]