User manual CANDY PL40

[. . . ] This appliance must be used by adults only. Make sure children do not touch the controls or play with the appliance. Installation and gas/electrical connections must be carried out by a qualified technician in accordance with the manufacturer's instructions and in full compliance with current laws and safety regulations. Electrical safety can only be guaranteed if the product is connected to a suitable earth connection. [. . . ] 4) next to the knobs indicate which knob corresponds to which burner. To choose the most suitable burner, take into account the diameter of the pan as well as the pan capacity (see table). The diameter of the pan must be proportionate to the burner power in order to ensure high yield. If a different type of gas from the one indicated on the rating plate is used, the injectors must be replaced. If spare injectors are not supplied with the appliance, they are available from the After-sales service. for the choice of replacement injectors , refer to the injectors table. The injectors are identified by their diameter, which is expressed in hundredths of mm, stamped on the body of the injector itself. 11) with the suitable ones for the gas used. After replacing the injectors, light the burner and remove the knob. 11) For gas G30/G31, tighten the adjustment screw fully The flame must be small, uniform and regular all around the burner crown. Finally, check that the flame does not go out by rapidly turning the tap from the maximum setting to the minimum. For burners with a safety device, check that the flame slightly licks the thermocouple. Make sure that the adjustment is correct by leaving the burner alight for a few minutes. The panstand grids are designed to make the appliance easy and safe to use. Always check the panstand grids are properly positioned before using the appliance. Furthermore, always check the protective rubber feet are all present and correctly positioned. This is placed on top of the auxiliary burner grid (the smallest one) when pots or pans of reduced diameter are used, to avoid unbalancing. These instructions are intended for qualified technicians. The appliance must be installed correctly, in compliance with current laws. Before carrying out any operation on the appliance, it must be disconnected from the electricity supply. The cooktop may be fitted into any worktop, as long as it is heat resistant (minimum temperature of 90°C). The dimensions of the hole to be made in the worktop and the minimum distances between rear and side walls and those above the appliance are shown in figures 5 and 6. [. . . ] The manufacturer declines all liability resulting from failure to observe this regulation. 12 ) If the power cable must be replaced, use a cable having identical characteristics to the original supplied by the manufacturer, suitable for the load and temperature (type T90°C). This is available from After-sales service. Furthermore, the end of the power cable to be connected to the appliance must have the Yellow-Green earth conductor 20 mm longer than the other conductors. [. . . ]