User manual CANDY PVC400X

[. . . ] 1 C D accessible space This appliance has been designed for non-professional, i. e. 2 31 32 IE GB If the hob is fitted above an oven which is not equipped with fan cooling system it is recommended that openings are created within the built in furniture to ensure correct air circulation. The size of these openings must be at least 300 cm2 and placed as shown in fig. ONLY) Warning - this appliance must be earthed This appliance is designed for domestic use only. [. . . ] The electric fan should be able to carry out a complete change of air in the kitchen 3-5 times every hour. The installer should follow the relavant national standards. GAS CONNECTION (FOR U. K. ONLY) The labels on the Hob indicate the types of gas that can be used. It is possible to use other types of gas after carrying out simple modifications. Warning: If gas can be smelt in the vicinity of this appliance turn off the gas supply to the appliance and call the engineer directly. Do not search for a leak with a naked flame. GB IE 33 34 GB IE ELECTRICAL CONNECTION Check the data on the rating plate, located on the outside of the unit, to ensure that the supply and input voltage are suitable. Before connection, check the earthing system. If this regulation is not complied with, the Manufacturer will not be responsible for any damage caused to persons or property. If a plug is not already attached, fit a plug appropriate to the load indicated on the rating plate. The earth wire is coloured yellow/green. Where the Hob is connected direct to the electricity supply, a circuit breaker must be fitted with at least a 3 mm contact spacing when in the open position. 5 mm 7 mm 15 mm 15 mm USE OF HOB USER INSTRUCTIONS This appliance must only be used for the purpose for which it is intended, domestic cooking, and any other use will be considered improper and could therefore be dangerous. The Manufacturer will not be responisble for any damage or loss resulting from improper use. SETTING OF THE GAS BURNERS When the jets have been changed it is necessary to set the correct air gap by keeping to the setting "X" as shown in the table " gas consumption" fig 7. Warning the value of ` X ` setting varies in relation to the size of gas burner and type of gas chosen. A good flame must be of medium length (fig. 8B), excessive air will cause the flame to be short and with sharp colour (fig. 8C): in this case it is necessary to extend out the tube for the air setting from the burner body, if there is insufficient air the flame will appear weak and long (fig. 8A): in this case push the tube of the air setting back into the burner body. To adjust the air setting tube loosen the retaining screw. Once the air is correctly set secure the screw over the tube ( fig. 7). For dimensions «X» see table of gas consumption BURNER FIXING SCREW SMALL MEDIUM LARGE USING THE GAS BURNER To ignite the burners, place a lighted taper close to the burner, press in and turn the control knob anti-clockwise. If the burners have not been used for a couple of days, wait for a few seconds before lighting the burner, this will allow any air present in the pipes to escape. For appliances fitted with electronic ignition carry out the following: · push in and turn the knob anticlockwise to the 5 symbol. · ignite the burner by pressing the sparker button. [. . . ] Such operation must be carried out only by qualified Service Engineers. Some model are equipped with a small steak griddle. This is only to be used over the medium size burner SEMIRAPID. This is a normal and inevitable phenomenon, but it doesn't jeopardize absolutely the functionality of the hob. [. . . ]