User manual CANDY PVI 630 C

[. . . ] This appliance is intended solely for domestic use and is designed for the following functions: cooking and reheating food. Any other use is considered as improper. The manufacturer declines all liability resulting from poor installation, tampering, inexpert use and use for purposes other than those specifically stated. Check that the appliance has not been damaged during transport. [. . . ] Using the burners For models fitted with ignition incorporated in the knobs, turn the gas tap knob to the maximum delivery position, then press and hold down for about 4÷ 5 seconds. Release the knob and adjust the flame by turning the knob to the desired intensity. For models fitted with ignition switch, turn the gas tap knob to the maximum delivery position, then press the ignition switch and the knob, holding down for about 4÷ 5 seconds. Then release the knob and adjust the flame by turning the knob to the desired intensity. 'Warning': The ignition device must not be used for more than 15 seconds. If after this length of time the burner does not light, or if it goes out again accidentally, wait 1 minute before trying to ignite the burner again. 4) next to the knobs indicate which knob corresponds to which burner. To choose the most suitable burner, take into account the diameter of the pan as well as the pan capacity (see table). The diameter of the pan must be proportionate to the burner power in order to ensure high yield. If a different type of gas from the one indicated on the rating plate is used, the injectors must be replaced. If spare injectors are not supplied with the appliance, they are available from the After-sales service. 5, so that the ends of the gasket meet exactly without overlapping. Position the cooktop into the worktop, taking care to ensure it is placed exactly in the centre. Fix the cooktop to the worktop using the special brackets supplied (A), as shown in fig. Correct installation of the sealing gasket (C) ensures complete protection against infiltration of liquids. The brackets must be fixed in the holes mark to you from the fig. The appliance must be installed and operated in suitable areas, and in compliance with current laws. Installation area In the room where the gas appliance is installed, there must be a sufficient natural air supply to allow the gas to burn correctly. The natural flow of air must take place through an opening made on an outside wall of the room and 2 having a working section of at least 100 cm (A). In the case of appliances without safety valves, this 2 opening must have a minimum working section of 200 cm (fig. This opening must be made in such a way that it cannot be obstructed from inside or outside. It should be positioned near floor level, preferably on the side opposite the fume exhaust devices. [. . . ] If the appliance is connected directly to the mains, fit an all-pole disconnect switch with minimum contact gap of 3 mm, adequate for the appliance load and complying to regulations. Do not use reducers, adapters or switches for connection to the mains, since these could overheat and cause burns. regulations require that the appliance is earthed. The manufacturer declines all liability resulting from failure to observe this regulation. [. . . ]