User manual CANDY RO 1486DWHC71-S

[. . . ] We are confident it will loyally assist you in safely washing your clothes, even delicates, day after day. Carefully read this manual for correct and safe appliance use and for helpful tips on efficient maintenance. Only use the washing machine after carefully reading these instructions. We recommend you always keep this manual on hand and in good condition for any future owners. [. . . ] L To delay the start use the following procedure: - Select the required programme. - Press the delay start button once to activate it (h00 appears on the display) and then press it again to set a 1 hour delay (h01 appears on the display). The pre-set delay increases by 1 hour each time the button is pressed, until h24 appears on the display, at which point pressing the button again will reset the delay start to zero. This button allows you to choose between three different options: - PREWASH L This option allows you to make a prewash and it is particularly useful for heavily soiled loads (can be used only on some programmes as shown in the table of programmes). L We recommend you use only 20% of the recommended quantities shown on the detergent pack. - EXTRA RINSE L This option allows you to add one rinse at the end of the washing cycle and is useful for people with delicate and sensitive skin, for which a small amount of detergent residue can cause irritations or allergies. L It is advisable to also use this function for the children clothes and for the washing of heavily soiled items, which requires a lot of detergent to be used, or for the washing of toweling items whose fibres mostly have the tendency to hold the detergent. This option allows deep cleaning of your clothes by maintaining the same temperature for the whole wash. L It is not possible to raise the temperature over the maximum allowed for the programme, in order to protect the fabrics. L If you want carry out a cold wash all the indicators must be off. If an option is selected that is not compatible with the selected programme then the option indicator light first flashes and then goes off. sTAIN LEVEL/ALTERNATIVE PROGRAMME SELECTION button This button can be used to select two different functions, depending on the selected programme: - STAIN LEVEL button L Once the programme has been selected the wash time set for that programme will be automatically shown. L This option allows you to choose between 3 levels of wash intensity modifying the length of the programme, depending on how much the fabrics are soiled (can only be used on some programmes as shown in the table of programmes). L By pressing this button, it is possible to reduce the maximum speed, and if you wish, the spin cycle can be cancelled. L If the label does not indicate specific information, it is possible to use the maximum spin expected in the program. To prevent damage to the fabrics, it is not possible to increase the speed over the maximum allowed for the programme. L To reactivate the spin cycle press the button until you reach the spin speed you would like to set. L It is possible to modify the spin speed without pausing the machine. Where shown in the table, this option permits selection of an alternative to the pre-set programme (in the case of the SAVING 14'-30'-44' programme, it allows you to choose one of the three available durations). tEMPERATURE SELECTION button L This button allows you to change the temperature of the wash cycles. If the appliance detects the presence of excessive foam, it may exclude the spinning phase or extend the duration of the program and increase water consumption. The machine is fitted with a special electronic device, which prevents the spin cycle should the load be unbalanced. [. . . ] Make sure transport screws, rubber bungs and spacer tubes were removed. Make sure there are no foreign objects inside the drum (coins, hinges, buttons, etc. The standard manufacturer warranty covers faults caused by electrical or mechanical faults in the product due to an act or omission of the manufacturer. If a fault is found to be caused by factors outside the product supplied, miss-use or as a result of the instructions on use not being followed, a charge may be applied. [. . . ]