User manual CANDY S 3.40

[. . . ] This appliance complies with Directives 89/336/EEC, 73/23/EEC and following changes. Q Do not touch the appliance with wet or damp hands or feet. Q Do not use the appliance when bare-footed. Q Extreme care should be taken if extension leads are used in bathrooms or shower rooms. [. . . ] It is better to connect the discharge hose to a fixed outlet of a diameter greater than that of the outlet tube and at a height of min. If is necessary to use the plastic sleeve supplied. EN Remove the key in "English" and apply to the inside of the door as indicate. Use front feet to level the machine with the floor. A) Turn the nut clockwise to release the screw adjuster of the foot. B) Rotate foot to raise or lower it until it stands firmly on the ground. C) Lock the foot in position by turning the nut anticlockwise until it comes up against the bottom of the machine. If this does not light up see faults search. After installation, the appliance must be positioned so that the plug is accessible. Detergent drawer Door open button Off/On button Reduced water level No spin button Wash control temperature knob Timer knob for wash programmes Off/On indicator light REDUCED WATER LEVEL The water level for a small wash may be reduced right through the wash from soaking to rinsing by pressing the 1/2 pushbutton, this way you will save electricity, detergent, and water too. WARNING: NEVER press the 1/2 pushbutton when you are washing PURE NEW WOOL, since wool absorbs water and therefore needs all the water the machine will hold. There are many detergents available in the market and making a choice from the wide range available can often be confusing. At Candy we regularly test many different types of detergent to assess which give the best wash results in our machines. We found only one brand always lives up to our exacting standards and provides outstanding cleaning across a broad range of dirt and stains, as well as providing high levels of fabric care. That's why Candy gave Ariel their official seal of approval. A guide environmentally friendly and economic use of your appliance. MAXIMISE THE LOAD SIZE Achieve the best use of energy, water, detergent and time by using the recommended maximum load size. Save up to 50% energy by washing a full load instead of 2 half loads. SAVE detergent, time, water and between 5 to 15% energy consumption by NOT selecting Prewash for slight to normally soiled laundry. Pretreat stains with stain remover or soak dried in stains in water before washing to reduce the necessity of a hot wash programme. Save up to 50% energy by using a 60°C wash programme. Let us suppose that the washing consists of HEAVILY SOILED COTTON (tough stains should be removed with suitable stain removal). [. . . ] Detach the drainage hose from the clamp and lower it over the bowl until all the water is removed. Repeat the same operation with the water inlet hose. Does not function on any programme CAUSE Mains plug not plugged in Mains switch not on No power Electric circuit fuses failure Load door open Insert plug Turn on mains switch Check Check Close load door Check Turn on water inlet tap Set timer on correct position Straighten discharge tube Replace washer and tighten the tube on the tap Wait a few minutes until the machine discharges water Turn the programme dial onto spin setting Adjust special feet Remove transport bracket Distribute the washing evenly See cause 1 Inlet tap turned off Timer not set correctly Discharge tube bent Leak from the washer between the tap and inlet tube The washing machine has not discharged water "No spin" setting (some models only) Strong vibrations during spin Washing machine not perfectly level Transport bracket not removed Washing load not evenly distributed For prompt servicing, give the model of the washing machine, to be found on the label placed on the cabinet inside of the porthole or on the guarantee certificate. Important 1 The use of environment friendly detersives without phosphates may produce the following effects: - The discharge rinse water may result cloudier due to the presence of zeolites in suspension. [. . . ]