User manual CANDY TRIO 503-1

[. . . ] This appliance is marked according to the European directive 2002/96/ EC on Waste Electrical and Electronic Equipment (WEEE). By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. The symbol on the product indicates that this product may not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment Disposal must be carried out in accordance with local environmental regulations for waste disposal. [. . . ] However, the appliance stops automatically when the door is opened. When the door is closed again, the programme continues automatically. If you wish to change or cancel a programme that is running, carry out the following procedure: . Open the door, keeping the Programme selection button "P" pressed in until all 4 indicator lights are flashing. Before starting a new programme, you should check that there is still detergent in the dispenser. WARNING: if the door is opened during the drying phase, an intermittent audible signal is activated to advise that the cycle is not yet completed. end of programme The end of the programme is indicated by an audible signal. When the door is opened the programme selection indicator lights start flashing. Deactivating the audible signal The audible function can be deactivated in the following way: - press the On / Off button - wait till the programme LEDs blink - within 2 minutes, press and keep pressed for at least 30 seconds the Programme Selection button (the programme LEDs will still blink and an intermittent audible signal is heard). - Once the first two LEDs on the left are illuminated without blinking and the audible signal is off, release the button (the audible signal function is active). - Press again the Programme Selection button, the first two LEDs on the left will go off and the other two LEDs will turn on (the audible signal function is deactivated) - An audible signal will confirm that the setting is completed - To set again the audible signal function repeat the whole procedure. Attention - The dishwasher is equipped with an anti-overflow safety device which in the event of anomaly intervenes by evacuating water in excess. Fault Signals If malfunctions or faults occur when a program is running, the LED that corresponds to the selected cycle (2 LEDS for COLD RINSE programme) will blink rapidly and an audible signal will be activated. In this case, turn the dishwasher off by pressing the On / Off button. After checking to make sure the water inlet hose tap is open, that the drain hose is not bent and that the siphon or filters are not clogged, re-start the selected program. To ensure the correct operation of the anti-overflow safety device, it is recommended not to move or to tilt the dishwasher during operation. If it is necessary to move or to tilt the dishwaher, first make sure the washing cyle is finished and that no water is left in the tank. PRELIMINARY OPERATIONS AND CLEANING THE FILTER UNIT The filtering system is composed of : - a central filter cup which traps the largest food particles. - a flat filter which continuously filters the washing water. - the micro filter, situated under the flat filter, which traps the smallest food particles ensuring a perfect rinse. For best results, the filter unit should be checked and cleaned after each wash. To remove the filter unit, simply grip the handle and lift the whole unit out. [. . . ] Never leave a scraper with a razor blade within reach of children. A few hints : Frequent cleaning leaves a protective layer which is essential for preventing scratches and wear. Make sure that the surface is clean before using the hob again. To remove marks left by water, use a few drops of white vinegar or lemon juice. [. . . ]