User manual CANNON CANTERBURY IN-BUILT MOCK

[. . . ] Any product subjected to misuse, abuse, negligence, accident or alteration will have its warranty voided. The defacement of serial plate will have it's warranty voided. If installation is not carried out in accordance with manufacturer's instructions, this warranty may be void. The customer must keep their "Tax Invoice" as proof of purchase of this product, and compliance certificate as proof of required installation. Model number: ______________________________________ Serial number: _______________________________________ Date of manufacture: _________________________________ Date installed: _______________________________________ Compliance Certificate No: ____________________________ Don't risk your appliance warranty Only a licensed person will give you a Compliance Certificate, showing that the work complies with all the relevant standards. [. . . ] If an abrasive cleaner is used the paint finish will be damaged. Internally the heater should only be cleaned by a licensed service person listed in this manual. If your heater requires attention contact your supplier or licensed service person listed in this manual. Important: The appliance should be inspected before use and at least annually by an authorised service person. More frequent cleaning may be required due to excessive lint build-up from carpeting, bedding materials, pet hair, etc. It is imperative that control compartments, burners and circulating air passage ways of the appliance be kept clean. Do not use this fire if the glass is cracked or with the glass safety screen removed. Do not use fire with broken or missing logs. 8 Installation Instructions 1. This appliance is to be installed by a licensed service person only. This appliance is to be installed in accordance with the manufacturer's installation instructions, AS 5601/AG601, Municipal Building Codes, Electrical Wiring Regulations and any other statutory regulations. Clearances 3. Ensure the minimum clearances to combustible construction are maintained during installation, including adequate space for the proper operation and servicing of the heater. 4 on single right back pin, ensure left side of log rests on depression in No. Refit the inner glass, but do not overtighten the screws. Ensure that the glass surround is replaced the correct side up. The rearward sloping frame must be at the top and the vertical ledge must be at the bottom. Refer figure 21. 21 Gas pressure point 16. Using an 8mm spanner remove the pressure point cover and check the outlet pressure of the gas regulator. It should be 1. 0 kPa for NG, 2. 75 for LP gas. Adjustment for LP gas is at the gas bottle regulator. The outlet pressure point is situated on the RHS top of the gas control. Follow User Instructions to turn on heater. Important: To achieve the correct visual flame effect: On Propane the gas pressure must be set at 2. 75 kPa with burner operating on maximum setting. [. . . ] The flue rise should be a minimum of 1. 8m before any horizontal run is used. Ensure clearances to combustible have been observed. The centre line of the flue is 75mm to rear of appliance (excl. Carry out installation as per figure 25 (ceiling plate installation) and figures 27 & 28 (flue installation). [. . . ]