User manual CANNON CANTERBURY CANTIBM

[. . . ] Cannon MAKER'S WARRANTY INBUILT MODELS CANTIB, CANTIBLP CANTIBM, CANTIBMLP USER INSTRUCTIONS INSTALLATION INSTRUCTIONS SERVICE INSTRUCTIONS This heater is approved for use with Natural and Propane gases. Please leave instructions with the owner Contents Contents Warranty Safety warnings What to do if you smell gas Warnings Standards User instructions Operating instructions Cleaning Heater specifications Installation instructions Clearances Installation into a masonry fire place Sealing Gas connection Fuel bed and log installation Gas control Gas pressure point Gas pressure sdjustment Service instructions General To replace the gas control To replace the fan To replace the electronic controller To remove the burner and electrodes To check pressures Trouble shooting Connections Electric wiring diagram Authorised service agents 18-19 17 15-16 13-14 9 10-12 6-8 2 3 4-5 2 Warranty The Cannon appliance is warranted against defects in materials and workmanship for a period of one, (1) year from its date of original purchase, for residential use in Australia. Warranty service, which includes parts and labour for the replacement or repair of defective parts, is available through Cannon Authorised Service Agencies. (Please refer to the list of authorised service agents in this manual. ) Consumers are responsible for service person's travel outside normal service areas (approximately seventy (70k) radius from the nearest Cannon dealer's location), local cartage, and normal maintenance as described in this manual. [. . . ] Prepare electrical and gas connections, a 10 Amp wall socket needs to be located within 1. 5m of the heater. Hard (fixed) wiring connection is to be carried out only by a qualified electrician. Remove the heater from the carton and remove the three transit screws. (Please dispose of packaging appropriately, keep away from children). Remove the front glass surround by holding it firmly on either side and pulling it towards yourself, see figure 11. 10 11 8. Remove the lower front cover by unscrewing two M5 screws through the air intake slots, see figure 12. If unit is fitted with supply flexible cord ensure that the cord cannot be trapped when the heater is installed. 12 13 9. Disconnect the switch loom connector from the loom plug. 10. To remove the front heater surround undo two s/t screws (one either side) from the bottom flange of the front panel as indicated in figure 14. Remove the surround by pulling the lower section towards you gently to partly disengage it from the the body of the heater, then gently lift it vertically to completely disengage it. Refer figure 15. 14 15 11 Installation instructions continued 11. Slacken off screws in top clamp and remove side clamps. Refer figure 16. 16 Sealing 12. All gaps between heater case and fireplace are to be sealed. Seal with foam tape around top and sides of heater flange as required. Seal with fibreglass between bottom of heater case and base of fireplace. 17a 17b 13. Slide heater into the fireplace ensuring that gas inlet pipe is fed through the hole at the rear bottom RHS of the heater. Refer figure 18 and gas connection figure 19. 18 - 14. With heater in position, flanges should be hard against 7asonry. Refer figure 16b. 12 Gas connection 15. Connect incoming gas supply pipe to regulator. Close gate over gas supply and seal around the pipe with fibreglass insulation material. [. . . ] A check between the earth pin on the plug and an unpainted part of the appliance should see a resistance of 0. 1 ohms. 5 Confirm spark is produced when heater is turned on. If no spark being produced 6 7 Spark is being produced but not at burner. Sparks, ignites on low flame then extinguishes after 10 seconds. Continues to spark during flame presence. 8 18 9 No gas to burner. · The gas valve should open at the same time as the igniter sparks. [. . . ]