User manual CANNON FITZROY PROFILE FREESTANDING

[. . . ] MAKER'S WARRANTY Cannon FITZROY PROFILE FREESTANDING MODELS FITZP, FITZLP USER INSTRUCTIONS INSTALLATION INSTRUCTIONS SERVICE INSTRUCTIONS This heater is approved for use with Natural and Propane gases. Please leave instructions with the owner Contents Contents Warranty Safety warnings What to do if you smell gas Warnings Standards User instructions Operating instructions Cleaning Heater specifications Installation instructions Clearances Installation Gas connection Fuel bed & log installation Gas control Gas pressure point 16-17 18-19 9 10-15 6-8 2 3 4-5 Flue installation Flue kit Service instructions General Access to components To replace the gas control To replace the fan To replace the electronic controller To remove the burner and electrodes Wiring diagram Authorised service agents Trouble shooting Connections Notes 20-21 22-23 2 Warranty The Cannon appliance is warranted against defects in materials and workmanship for a period of one, (1) year from its date of original purchase, for residential use in Australia. Warranty service, which includes parts and labour for the replacement or repair of defective parts, is available through Cannon Authorised Service Agencies. (Please refer to the list of authorised service agents in this manual. ) Consumers are responsible for service person's travel outside normal service areas (approximately seventy (70k) radius from the nearest Cannon dealer's location), local cartage, and normal maintenance as described in this manual. [. . . ] Fit rear spacers as per figure 10. Installation 7. (Check flue and gas connection positions. Refer to gas connection instructions on page 12 and flue installation instructions on pages 14 & 15). Remove the pedestal front by unscrewing two screws either side. Refer figure 11. 10 11 12 9. Remove the heater front securing screws, one either side. 10. Remove the heater front by pulling it towards you gently to partly disengage it from the body of the heater then gently lift it up vertically to completely disengage it. Refer figure 13. 13 11. Remove the inner glass. Slacken off screws in top clamp and remove side clamps. Refer figure 14. 14 11 Installation instructions continued Gas connection 12. Connect incoming gas supply pipe at gas control inlet. The inlet fitting is located 150mm in from the rear pedestal wall RH side. Refer figure 15. 15 Fuel bed and log installation 13. The fuel bed is contained within the burner chamber. The fuel bed is retained by a spring clip fixed to the rear of the burner chamber FUEL BED MUST BE HARD UP AGAINST REAR OF BURNER 16 14. Logs are numbered as follows: No 1 - Left front log No 2 - left back log No 3 - Right front log No 4 - Right back log Position the four individually numbered logs in the following order on the fuel bed as shown in figures 17-20. The male locating pins in fuel bed must engage with corresponding holes in the individual logs. a) Place log No. 1 onto the 2 front left pins on the fuel bed. Refer figure 17. 17 12 b) Place log No. 2 onto the 2 left back pins. Refer figure 18. 18 c) Place log No. 3 on single right front pin, ensure fork locates over log No. Refer figure 19. 19 d) Place log No. 4 on single right back pin, ensure left side of log rests on depression in No. [. . . ] · Check that the sense electrode is in the flame. · Check that appliance is earthed correctly. A check between the earth pin on the plug and an unpainted part of the appliance should see a resistance of 0. 1 ohms. 5 Confirm spark is produced when heater is turned on. If no spark being produced 6 7 Spark is being produced but not at burner. [. . . ]