User manual CANNON FITZROYIN-BUILT MOCK

[. . . ] Any product subjected to misuse, abuse, negligence, accident or alteration will have its warranty voided. The defacement of serial plate will have its warranty voided. If installation is not carried out in accordance with manufacturer's instructions, this warranty may be void. The customer must keep their "Tax Invoice" as proof of purchase of this product, and compliance certificate as proof of required installation. Model number: ______________________________________ Serial number: _______________________________________ Date of manufacture: _________________________________ Date installed: _______________________________________ Compliance Certificate No: ____________________________ Don't risk your appliance warranty Only a licensed person will give you a Compliance Certificate, showing that the work complies with all the relevant standards. [. . . ] This appliance is to be installed in accordance with the manufacturer's installation instructions, AS 5601/AG 601, Municipal Building Codes, Electrical Wiring Regulations and any other statutory regulations. Clearances 3. Ensure the minimum clearances to combustible construction are maintained during installation, including adequate space for the proper operation and servicing of the heater. For clearances to curtains and furnishing refer to warning 3 on page 4. For minimum clearances refer fig 9 and 10. 9 10 4. Remove the carton from the heater and lift from pallet. Check that the heater is suitable for the gas available (Please dispose of packaging appropriately, keep away from children). Prepare electrical and gas connections, a 10 Amp wall socket needs to be located within 1. 5m of the heater. Fit rear spacers as per figure 10. Installation 7. (Check flue and gas connection positions. Refer to gas connection instructions on page 12 and flue installation instructions on pages 14 & 15). Remove the pedestal front by unscrewing two screws either side. Turn screw 6 revolution anticlockwise to open the pressure point as indicated on figure 23 (a) and place manometer tube over the test point as per figure 23 (b). 23 19. Switch the top two control buttons to "Full On" position as indicated in figure 24(a) and using a ring spanner, as per figure 24(b), adjust the pressure to 1kPa for Natural gas or 2. 65 kPa for LPG. (Turn clockwise to increase pressure and anticlockwise to decrease pressure). 24 20. Switch the stop button back to "Low Flame' position as indicated in figure 25(a), retain spanner in position and using a screwdriver as per figure 25(b) adjust the central screw control to give a pressure reading of 0. 3 kPa for Natural Gas and 1. 1 kPa for LPG. (Turn clock-wise to increase pressure and anticlockwise to decrease pressure). 14 25 27. Switch burners off and remove the manometer tube. Tighten pressure test point by turning the captive screw fully clockwise. Ensure the little lug is positioned towards lower right hand side to clear the control. Refit the lower front cover, making sure not to damage the power cord. Follow User Instructions to turn on heater. Important: To achieve the correct visual flame effect: On Propane the gas pressure must be set at 2. 65 kPa with burner operating on maximum setting. [. . . ] If there is no spark to earth then change the module. Check the spark ceramic insulator for signs of cracks. · Check that the wall socket to the appliance has correct polarity. Check polarity in the electrical supply lead to appliance. [. . . ]