User manual CANNON HB1113296

[. . . ] Any product subjected to misuse, abuse, negligence, accident or alteration will have its warranty voided. The defacement of serial plate will have it's warranty voided. If installation is not carried out in accordance with manufacturer's instructions, this warranty may be void. The customer must keep their "Tax Invoice" as proof of purchase of this product and compliance certificate as proof of required installation. [. . . ] Gas type: Gas consumption: Energy star rating: Energy output: Heater type: Operating pressure: Gas regulator: Min. inlet pressure: Natural or Propane gas, as indicated on data label 26 MJ/hr input 3. 77 20. 7 MJ/hr Heater approved to AG 103. Natural gas: 1. 0 kPa Propane gas: 2. 65 kPa Integral with controller (NG) 1. 13 kPa (NG) Propane gas: Regulated to supply 2. 70 kPa to appliance Fan: Controller: Minimum cavity dimensions Power requirement: Optional Accessories: Three speed Electronic Height: 605mm dimensions* Width: 695mm Depth: 385mm 240 VAC 10 A · Safety guard · Gold trim · Mock fireplace installation kit* Refer fig. 8 *For installation into a non-combustible fireplace, ie: masonry or brick or into a mock fireplace, i. e. Note: when installing into a mock fireplace a mock fireplace heater must be used. Model no's: CANTIBM & CANTIBMLP. Overall dimensions: 8 9 Installation Instructions 1. This appliance is to be installed by a licensed service person only. This appliance is to be installed in accordance with the manufacturer's installation instructions, AS 5601/AG 601, Municipal Building Codes, Electrical Wiring Regulations and any other statutory regulations. Clearances 3. Ensure the minimum clearances to combustible construction are maintained during installation, including adequate space for the proper operation and servicing of the heater. Keep curtains*, furniture and other flammable materials at least 900mm from front of heater. * Curtain clearance can be less than 900mm as long as they are restained from sides and front of heater. With heater in position, flanges should be hard against 7asonry. Refer figure 16b. 12 Gas connection 15. Connect incoming gas supply pipe to regulator. Close gate over gas supply and seal around the pipe with fibreglass insulation material. Sealing is important as it prevents leakage from fan chamber into chimney: also check for gas soundness. 19 Fuel bed and log installation 16. The fuel bed is contained within the burner chamber. The fuel bed is retained by a spring clip fixed to the rear of the burner chamber FUEL BED MUST BE HARD UP AGAINST REAR OF BURNER. 20 17. Logs are numbered as follows: No 1 - Left front log No 2 - left back log No 3 - Right front log No 4 - Right back log Position the four individually numbered logs in the following order on the fuel bed as shown in figure 21-24. The male locating pins in fuel bed must engage with corresponding holes in the individual logs. a) Place log No. 1 onto the 2 front left pins on the fuel bed, see figure 21. 21 13 b) Place log No. 2 onto the 2 left back pins. Refer figure 22. 22 c) Place log No. 3 on single right front pin, ensure fork locates over log No. [. . . ] · Check that the wall socket to the appliance has correct polarity. Check polarity in the electrical supply lead to appliance. · Check that the sense electrode is in the flame. · Check that appliance is earthed correctly. [. . . ]