User manual CANNON HB40042G

[. . . ] The heater will only operate if the actual room temperature is lower than the required temperature. Manual Mode: Press "A/M" Button to select "Manual" mode. The required temperature can be selected by using `UP ' or `DOWN ' buttons. Room temperature is shown at top of screen. [. . . ] The fan ranges are graduated settings: 1, 2, 3. Page 6. MANUAL AUTO Fan indicator Functions Button Functions Button PWR Function On Description Switches the thermostat on. If the thermostat is off, pressing and releasing the PWR and OK button together will turn the thermostat on to the most recently selected working mode. Switches the unit off. PWR PWR OK PWR Off OK OK Enter Accepts the current function and advances the next function. Increment hours, minutes, day or temperature. Decrement hours, minutes, day or temperature. UP UP DOWN DOWN A/M A/M Automatic Toggles between automatic and manual / Manual mode. Programming button function T T Time Indicates time and day of the week programming (must press and hold for 2 or more seconds when thermostat is off). Indicates the programming mode (must press and hold for 2 or more seconds when thermostat is off). P P Program Page 7. Initial Setup ON If the `PWR ' is off, the heater will not start. Press and release the `PWR ' and `OK' buttons together, pressing and releasing `PWR ' and `OK' buttons will turn the thermostat on to the most recently selected working mode or the factory default setting if not previously programmed. Note small Red LED Display light will be displayed constantly while heater is on. Will flash intermittently when unit is not in operation. OFF Press and release the `PWR ' will shut unit down. With the thermostat off, press and hold the `T' button for 2 seconds or longer to initiate programming the time. Time, the hour setting and the AM / PM will flash. The automatic mode allows the temperature to be regulated according to a programmed level and time. With the thermostat on, press and release the `A/M ' button until the word AUTO appears on the LCD. To correctly operate in automatic mode, the time and day of the week must be set. The thermostat will now operate according to the program set for the current time period. Programming instructions are found on page 10. At any time, the temperature or fan speed may be adjusted up or down similar to operating in manual mode. However, whenever the thermostat changes to a new time period, the temperature will be reset automatically according to that period's setting. Page 9. Programming Each day of the week can be programmed individually for periods P1, P2, P3, and P4, making a total of 28 programmed periods. Alternatively, a weekday program can be set, so the same program is used for Monday to Friday. Similarly, a weekday program can be set for Saturday - Sunday. The entire week can also have the same program. Alternatively, a weekday or weekend program can be set with individual programs for the remaining days. [. . . ] Factory default settings have been lost. Reset the time and day of the week as was required in the initial set up. Once the default settings have been reset, the thermostat must be reprogrammed. for initial set up and pages 9-11 for programming the automatic mode. [. . . ]