User manual CANNON MAG 20DT

[. . . ] NOTE: Do not return your CANNON® Downrigger to your retailer. Your retailer is not authorized to repair or replace this unit. You may obtain service by: calling CANNON® at 1-800-227-6433; returning your downrigger to the Factory Service Center; sending or taking your downrigger to any CANNON® Authorized Service Center on enclosed list. Please include proof of purchase, serial number and purchase date for warranty service with any of the above options. [. . . ] Turning the knob counterclockwise (away from the boom) stops the weight. This gives you control to let it plunge rapidly or sink slowly to a predetermined trolling depth. With multiple downriggers, you could start all your weights creeping down, one at a time, and then stop them each in turn. Powered Descent: One speed fits all Hold the toggle switch down until the weight reaches the desired depth and release. The motor will stop when switch is released or moved to the neutral position. Le support de cannes à pêche à autoverrouillage comprend un disque de verrouillage qui permet d'aligner le support de cannes à pêche à des intervalles de 15 degrés. NOTE: Make sure that the clutch is well tightened when using powered descent or ascent. NOTE: Actual fishing depth may vary from depth shown on meter due to trolling speed and weight of cannon ball. (See "Blowback") NOTE: If your reel continues to slip no matter how hard you tighten the brake adjust knob, try this suggestion. Align set screw hole in reel with reel shaft hole by inserting 3/16" or smaller rod. Rotate the reel until you feel the rod drop into the shaft hole. Replace the set screw and tighten until you feel resistance. By gently rocking the reel back and forth while you finish tightening the set screw, you can feel it engage the shaft hole. The half dog point on the set screw MUST enter the shaft hole, not just be tightened against the shaft. Caution: The brake adjust knob (clutch) should be adjusted so that it is tight enough to hold the weight and the lure at the speed you are trolling. Over tightening may cause damage to your downrigger when weight hangs up on bottom structure or other obstacles. raising the Weight Push the toggle switch up momentarily and release. The weight will rise until it reaches the surface and then automatically stop. If you want to raise the weight farther push the toggle switch up and hold until the weight reaches the desired position, then release. To stop the weight during ascent, push the toggle switch down momentarily (approximately 1 second). adjusting the Depth Meter The Cannon Depth Meter provides non-slip accuracy , plus easy resetting. To reset, just slide the meter away from the reel until the gears are disengaged. [. . . ] This limited warranty may be enforced only by the original purchaser; all subsequent purchasers acquire the product "as is" without any benefit of this limited warranty. Repair or replacement of the product as set forth in this limited warranty shall be the original purchaser's sole and exclusive remedy and Johnson Outdoors Inc. 's sole and exclusive liability for breach of this warranty. EXCLUSIONS This warranty does not apply in the following circumstances: When the product has been connected, installed, combined, altered, adjusted, serviced, repaired, or handled in a manner other than according to the instructions furnished with the product When a serial number has been effaced, altered, or removed When any defect, problem, loss, or damage has resulted from any accident, misuse, negligence, carelessness, or abnormal use, or from any failure to provide reasonable and necessary maintenance in accordance with the instructions of the owner's manual LIMITATION AND EXCLUSION OF IMPLIED WARRANTIES AND CERTAIN DAMAGES THERE ARE NO EXPRESS WARRANTIES OTHER THAN THESE LIMITED WARRANTIES. [. . . ]