User manual CANNONDALE C440-2002

[. . . ] 2002 MOTORCYCLE OWNER'S MANUAL (E440, C440, X440) · Safety · Operation · Maintenance Before you operate the vehicle. . · READ and UNDERSTAND this manual. It contains information important to your safety. Familiarize yourself with all vehicle controls and their proper operation. [. . . ] For example, if you ride in sandy conditions, the time (interval) between servicing will be shortened since sand is very abrasive and will act to wear vehicle components more quickly. the seat, look for "QR. " When the latch is released from the catch on the subframe, the rear of the seat should rise slightly. If you do not feel comfortable or in any way doubt your own abilities to perform a procedure described in this manual, don't attempt it. Have an authorized Cannondale Motorsports Dealer perform the servicing. Many maintenance procedures found in this section require the use of a "torque wrench, " - a special tool enabling a precise tightness to be applied to a fastener. If you do not have a torque wrench or are not familiar with using one; contact your authorized Cannondale Dealer for assistance. 1 SE AT SEAT REMOVAL 3. Slide the seat towards the rear of the vehicle and off the retaining tabs on the gas tank. 1. Position the vehicle on a level surface so that there is no danger of it falling over while you work. Press down slightly on the rear of the seat with one hand while pulling up on the quick release lever with a finger of the other hand. The quick release lever is located on the rear left side of Motorcycle Maintenance and Adjustment. fm © 2001 Cannondale Corporation - All Rights Reserved 48 4. Examine the receivers (slots) on the bottom of the seat pan. If damage is found, replace the seat with a new one. 5. Test similarly at the front of the seat. SEAT INSTALLATION 1. To install the seat, align the retaining tabs on the fuel tank with the receivers on the underside of the seat. POTENTIAL HAZARD Unlatched, or damaged seat WHAT CAN HAPPEN If you install the seat incorrectly (not latched) or if the seat is damaged, it can shift or come off while you are riding causing you to lose control. You could be seriously injured or killed in an accident. HOW TO AVOID THE HAZARD 2. Hold up on the release lever and push the rear of the seat down and release the lever. You should hear the lever "snap" or "click" onto the latch on the subframe. Test to confirm that the seat is latched properly by lifting the rear of the seat up with your fingers. Make sure the seat is fastened securely and it is in good condition. After installing the seat, pull the front and rear of the seat upwards to make sure it is latched and locked into position. If the seat is loose or unlatched, correct the situation before riding. Contact your Cannondale Dealer for a replacement seat if damaged. 49 Printed : 1/9/02 FUEL THROTTLE FREEPLAY ADJUSTMENT FUEL TANK REMOVAL POTENTIAL HAZARD 1. To adjust the freeplay at the grip, slide boot back to expose lock ring and adjuster. Loosen the lock ring and turn the adjuster until the specified freeplay is reached. Tighten the lock ring securely when finished and return the boot. Fuel fire or explosion WHAT CAN HAPPEN The fuel tank on your vehicle has been designed to be removed without having to drain the fuel from it. However, gasoline is extremely flammable and can explode under certain conditions. [. . . ] Select a cool dry place away from heat, humidity and dust and dirt to store the vehicle. Cover the vehicle. Make any necessary repairs before storing the vehicle. If you don't have the opportunity to service before storage, write down all needed repairs on a tag and attach the tag the handlebars to act as a reminder later. REMOVING FROM STORAGE 1. Uncover the vehicle, and then clean and dry it. [. . . ]