User manual CANON CANOSCAN-4400F

[. . . ] ⷠWhen locking the scanner, do not lift up the back and tilt the front (scanner button location) downward. 1 Connect the scanner to your computer with the supplied USB cable. Only use the USB cable and the AC adapter provided with the scanner. [. . . ] When you finish scanning, put the protective sheet back by aligning it with the grooves in the document cover and sliding it downward into place. Always put the protective sheet back when you are not scanning film to protect the light source in the document cover. Hold the document cover so that it doesn't close, then a press down and hold the tab at the Film Guide's top left and b tilt the Film Guide outward to lift it up. Use a blower brush to remove any dust from the film, which will affect the image quality, and take care to hold the film by its edges to avoid transferring dirt or fingerprints to it. ⷠDo not block the calibration slot on the Film Guide when scanning film. Press lightly until it clicks into place. When scanning short or curled film, extra light may enter through gaps and produce bands of color around the edges of the scanned image. If this occurs, use the supplied shield as shown in the figure. Document cover, and close the document cover. Hold the document cover and a insert the bottom edge of the Film Guide into the bottom groove in the document cover, and then b tilt the top of the Film Guide up into the document cover until it locks securely into place with a click. Film (Color)] in [Select Source] to match the type of film you are scanning, then click [Preview]. Do not touch the scanner while it is operating. Do not leave the film strip in the film guide for an extended period of time as heat from the unit may damage the film. Flatbed CCD 6-line color Cold cathode fluorescent lamp 4800 x 9600 dpi 25­19200 dpi (ScanGear) Color 48 bit input (16 bit for each color) 48 bit or 24 bit output (16 bit or 8 bit for each color) 48 bit input (16 bit for each color) 16 bit *2 or 8 bit output 7. Scanning speed varies according to the document types, scan settings, or specifications of the computer. *4 Calibration processing time is not included. [. . . ] Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ]