User manual CANON DIGISUPER 100 XS BROCHURE

[. . . ] Canon shall not be liable for any damage to this product and/or accidents such as fire, etc. , caused by the malfunction of non-genuine Canon accessories (e. g. , a leakage and/or explosion of a battery pack). Please note that this warranty does not apply to repairs arising out of the malfunction of non-genuine Canon accessories, although you may request such repairs on a chargeable basis. Camera Body Temperature If your camera is used for prolonged periods, the camera body may become warm. Please be aware of this and take care when operating the camera for an extended period. About the LCD Monitor The LCD monitor is produced with extremely high-precision manufacturing techniques. More than 99. 99% of the pixels operate to specification. [. . . ] · Be careful not to touch the microphone while recording. · Do not press buttons other than the shutter button while filming to avoid inadvertent recording of the operation sounds. · The AF and zoom settings remain fixed for subsequent frames at the values selected for the first frame. · During filming, the camera will automatically correct the exposure and white balance settings to suit the shooting conditions. Please note, however, that the sounds made by the automatic settings adjustment may also be recorded. · After a clip is shot, the indicator will blink green while the clip is being written to the SD card. You cannot shoot again until the blinking stops. · · · · See Functions Available in Each Shooting Mode (p. There is no shutter sound in movie mode. You can adjust the exposure compensation setting before shooting. Press the button to lock the exposure setting (AE lock) and display the exposure compensation bar in the LCD monitor. 49). 3 Use the or button to select a shooting direction and press the FUNC. /SET button. 83 4 Shoot the first frame in the sequence. The exposure and white balance are set and locked with the first image. 5 Compose the second image so that it overlaps a portion of the first and shoot. · Use the or button to check or retake the recorded images. · Minor discrepancies in the overlapping portions can be corrected when the images are stitched together. 6 7 Repeat the procedure for additional images. A sequence may contain up to 26 images. Press the MENU button after the last shot. The Stitch Assist session ends. Press the MENU button again to return to the shooting screen. · A custom white balance setting cannot be set in Stitch Assist mode. To use a custom white balance setting, set it before selecting [Stitch Assist] in the Rec. · The settings for the first image are used to take subsequent images in the sequence. · It is not possible to display images on the TV when shooting in Stitch Assist mode. See Functions Available in Each Shooting Mode (p. 176). 84 Switching between Focusing Modes Shooting Mode Although the autofocus function is preset to the AiAF setting (9 AF frames), you can set it to the center AF frame. When [AiAF] is set to [On], the AF frame does not appear. When [AiAF] is set to [Off], however, the AF frame will appear. No frame On Off The The camera detects the subject and highlights the AF frames, from 9 available points, that it will use to determine the focus. Shooting The camera focuses using the center AF frame. This is convenient for focusing on a specific part of a subject with greater certainty. symbol represents the AF frames as they appear in the LCD monitor. 1 In the [AiAF]. (Rec. ) menu, select See Selecting Menus and Settings (p. [. . . ] All rights reserved. 174 FCC Notice (Digital Camera, Model PC1101/PC1102) This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions; (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for Class B digital devices, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. [. . . ]