User manual CANON DIGITAL REBEL XTI SILVER BROCHURE

[. . . ] Canon shall not be liable for any damage to this product and/or accidents such as fire, etc. , caused by the malfunction of non-genuine Canon accessories (e. g. , a leakage and/ or explosion of a battery pack). Please note that this warranty does not apply to repairs arising out of the malfunction of non-genuine Canon accessories, although you may request such repairs on a chargeable basis. Camera Body Temperature If your camera is used for prolonged periods, the camera body may become warm. Please be aware of this and take care when operating the camera for an extended period. About the LCD Monitor The LCD monitor is produced with extremely high-precision manufacturing techniques. More than 99. 99% of the pixels operate to specification. [. . . ] menu, select * The current setting is displayed. *. See Selecting Menus and Settings (p. 43). 2 Use the or button to adjust the exposure compensation. · The settings can be adjusted in 1/3 stops in the range -2 to +2. · You can confirm the effect of the setting in the LCD monitor when it is on. · You can shoot right after selecting an option. The menu displays again after the shot, allowing you to change the settings easily. 3 Return the setting to 0. Press the FUNC. button. The display will return to the Shooting screen. To reset the exposure compensation 78 Shooting in Long Shutter Mode You can set the shutter speed to a slow setting to make dark subjects appear brighter. 1 In the (Rec. ) menu, select . See Selecting Menus and Settings (p. 43). Shooting 2 Use the or button to select [On] and press the MENU button. The display will return to the Shooting screen. 3 In the FUNC. menu, select press the SET button. * The current setting is displayed. * and See Selecting Menus and Settings (p. 43). 4 Use the or button to select a shutter speed. · The higher the value, the brighter the image and the lower the value, the darker the image. · You can shoot right after selecting a value. The menu displays again after the shot, allowing you to change the settings easily. 79 5 Press the FUNC. Especially in the following cases, as the white balance may not be adjusted in (Auto), shoot after reading the white balance data in (Custom). · Shooting close-ups · Shooting subjects of monotone color (such as sky, sea or forest) · Shooting with a peculiar source of light (such as a mercury-vapor lamp) 1 In the FUNC. menu, select * The current setting is displayed. *. See Selecting Menus and Settings (p. 43). 2 Use the or button to select . 82 3 Aim the camera at the white paper, cloth or gray card and press the SET button. · Aim the camera so that the white paper, cloth or gray card completely fills the frame on the LCD monitor or the entire viewfinder before pressing the SET button. The camera reads the white balance data when you press the SET button. · You can shoot right after selecting an option. The menu displays again after the shot, allowing you to change the settings easily. Shooting 4 Press the FUNC. button. The display will return to the Shooting screen. · You are recommended to set the shooting mode to and the exposure compensation setting to zero (±0) before setting a custom white balance. The correct white balance may not be obtained when the exposure setting is incorrect (image appears completely black or white). · Shoot with the same settings as when reading the white balance data. If the settings differ, the optimal white balance may not be set. [. . . ] All rights reserved. · · · · 158 FCC Notice (Digital Camera, Model PC1084/1086) This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions; (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for Class B digital devices, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. [. . . ]