User manual CANON ELURA 20 MC

[. . . ] If you have any questions, call the Canon U. If you have any questions, call the Canon Canada Information Center toll-free at 1-800-828-4040. This instruction book explains the use of the ELURA10 and ELURA20 MC camcorders. The only difference between these models is that the ELURA20 MC includes a Memory Card function. [. . . ] DATE is turned on but DISPLAYS ( second auto date will still appear for 6 seconds. This allows you to move quickly through still pictures recorded anywhere on a tape (photo search) or between different days or areas of recording (date search) on a tape. Press the - and + buttons to move backwards or forwards through the still pictures or between different days of recording. Press once to move to the start of the previous/next still picture or day on the tape. You can press more than once to move to the corresponding still picture or day (up to a maximum of 10 times), e. Press the + button 5 times to move forward 5 still pictures or days. PHOTO SEARCH/DATE SEARCH appears in the middle of the display alongside the - or + mark and number to search through. If you begin a search very close to the start of a recorded still picture during photo search, the camera may skip straight past it. When you have set the area for the World Clock, date search also looks for the change in date based on the adjusted time. A date/area cannot be identified if the total recording time on that day/area was less than 1 minute. Date search playback may start just before or after the beginning of the located section. If the data code is not displayed correctly you will not be able to operate the date search correctly. Use the wireless controller to mark a point on a tape that you want to return to following playback. Press the ZERO SET MEMORY button on the wireless controller during playback at a point you want to return to later. When you have finished playback, fast forward or rewind the tape. The tape stops automatically when it reaches the zero set position. The tape counter with  indication disappears from the display and the time code reappears. The zero set memory may not function correctly where there is a break between recordings on the tape. You can also use zero set memory to mark a position on a tape in camera mode. When you then play back the tape, pressing rewind will take you back to the pre-marked position. If you remove the tape while the zero set memory is set, the memory is canceled and the tape counter reverts to time code. The camera remembers your setting even if you turn it off and back on again or move the program selector. [. . . ] In either case you will be directerd to ship the DV Camcorder, postage prepaid, to the CUSA Center or Service Facility nearest to you. You must include a copy of the proof of purchase (bill of sale) and a complete explanation of the problem. DV Camcorders covered by this limited warranty will be repaired and returned to you without charge by the CUSA Center or the Service Facility. Repairs not under warranty will be at such cost as the CUSA Center or Service Facility may from time to time generally establish. [. . . ]